User manual FUJITSU B2175

[. . . ] Copyright Copyright Fujitsu PC Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Fujitsu and the Fujitsu logo are registered trademarks and LifeBook is a trademark of Fujitsu Limited. [. . . ] Press the connector edge of the module firmly down and into the connector until it lodges under the retaining clip. You will hear a click when it is properly in place. (Figure 4-7) INSTALLING A MEMORY UPGRADE MODULE 1. Turn off power to your LifeBook using the power switch, and remove any attached power adapter (AC or auto/airline). Make sure that all connector covers are closed. Turn the LifeBook bottom side up, with the front panel toward you. Remove the screws of the memory upgrade module compartment. Remove the cover. Figure 4-7 Installing a Memory Upgrade Module 9. POINT The memory upgrade module is not something you routinely remove from your LifeBook. Once it is installed, you should leave it in place unless you want to change system memory capacity. REMOVING A MEMORY UPGRADE MODULE 1. Perform steps 1 through 5 of Installing a Memory Upgrade Module. Pull the clips sideways away from each side of the memory upgrade module at the same time. While holding the clips out, remove the module from the slot by lifting it up and pulling towards the rear of your LifeBook. (Figure 4-8) Figure 4-6 Opening the Memory Upgrade Compartment CAUTION The memory upgrade module can be severely damaged by electrostatic discharge (ESD). Be sure you are properly grounded when handling and installing the module. Figure 4-8 Removing a Memory Upgrade Module 6. Remove the memory upgrade module from the static guarded sleeve. Align the memory upgrade module with the part side up. Align the connector edge of the memory 42 4. Store the memory upgrade module in a static guarded sleeve. User Installable Features 5. Replace the cover by following steps 9 and 10 of Installing a Memory Upgrade Module. POINT After installing your new memory module, you must complete the Resetting the Save-to-Disk Parameters procedure in order for the Save-to-Disk mode to operate properly on your LifeBook. See "Save-to-Disk Mode (Windows 98 Second Edition models only)" on page 32. CHECKING THE COMPUTER RECOGNITION OF NEW MEMORY CAPACITY Once you have changed the system memory capacity, be sure to check that your LifeBook has recognized the change. [. . . ] SMART predictability is limited to those attributes which the drive can self-monitor. In those cases where SMART can give advance warning, a considerable amount of precious data can be saved. A specific technology of making RAM which does not require periodic data refreshing. Status Indicator A display which reports the condition of some portion of your hardware. [. . . ]