User manual FUJITSU C1410

[. . . ] clio. book Page 1 Friday, June 2, 2006 10:37 AM Fujitsu LifeBook C1410 Notebook ® User's Guide clio. book Page 2 Friday, June 2, 2006 10:37 AM clio. book Page 3 Friday, June 2, 2006 10:37 AM Copyright Copyright and Trademark Information Fujitsu Computer Systems Corporation has made every effort to ensure the accuracy and completeness of this document; however, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. MS, MS-DOS, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. [. . . ] Remove and re-dock your LifeBook notebook. Eject the floppy disk and set it to write enable. (See Preparing a Disk for Use on page 38 for more information) Eject floppy disk, check orientation and re-insert. (See Ejecting a Disk on page 38 for more information) Remove and re-install your floppy disk drive. Verify your password and security settings. Verify drive designator used by application is in use by the operating system. When the operating system is booted from a CD, drive designations are automatically adjusted. Verify your password and security settings. You have connected an external keyboard or a mouse and it seems to be locking up the system. clio. book Page 52 Friday, June 2, 2006 10:37 AM LifeBook C1400 Series Notebook - Section Five Problem Possible Cause Possible Solutions Memory Problems Your Power On screen, or Main menu of the BIOS setup utility information, does not show the correct amount of installed memory. Modem Problems Messages about modem operation. Modem operation messages are generated by whichever modem application is in use. See your application software documentation for additional information. Your memory upgrade module is not properly installed. Remove and re-install your memory upgrade module. (See Memory Upgrade Module on page 42 for more information) Check for Power On Self Test (POST) messages. (See Power On Self Test Messages on page 57 for more information) Parallel, Serial, and USB Device Problems You have installed a parallel port device, a serial port device or a USB device. Your LifeBook notebook does not recognize the device, or the device does not seem to work properly. The device may have been installed while an application was running, so your notebook is not aware of its installation. Your device may not have the correct software driver active. You may have the wrong I/O address selected for the device. (See Device Ports on page 44 for more information) Close the application and restart your notebook. See your software documentation and activate the correct driver. See your device documentation and software documentation to determine the required I/O address. Change the settings in the BIOS setup utility. (See BIOS Setup Utility on page 27 for more information) Check all I/O addresses located within the BIOS setup utility and any other installed hardware or software to make sure there are no duplications. Check parallel port setting in the BIOS and set to bi-directional or ECP. Your device and another device are assigned the same I/O address. [. . . ] Equipment (or its transmit antenna) that is installed outdoors is subject to licensing. Warranty Users are not authorized to modify this product. Any modifications invalidate the warranty. This equipment may not be modified, altered, or changed in any way without signed written permission from Fujitsu. [. . . ]