User manual FUJITSU S6110

[. . . ] Copyright Copyright Fujitsu PC Corporation has made every effort to ensure the accuracy and completeness of this document; however, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. [. . . ] Change the settings in the BIOS setup utility. (See BIOS Setup Utility on page 29 for more information) Check all I/O addresses located within the BIOS setup utility and any other installed hardware or software to make sure there are no duplications. Check parallel port setting in the BIOS and set to bi-directional or ECP. PC Card Problems A card inserted in the PC Card slot does not work or is locking up the system. The card may have been installed while an application was running, so your notebook is not aware of its installation. Your software may not have the correct software driver active. You may have the wrong I/O address selected for your PC Card device. Your PC Card device and another device are assigned the same I/O address. Power Failures You turn on your LifeBook notebook and nothing seems to happen. The installed primary battery is completely discharged, there is no optional second battery installed or there is no Power adapter (AC or Auto/Airline) installed. The primary battery is installed but is faulty. Check the Status Indicator Panel to determine the presence and condition of the batteries. (See Status Indicator Panel on page 11 for more information) Install a charged battery or a Power adapter. (See PC Cards on page 43 for more information) Close the application and restart your notebook. See your software documentation and activate the correct driver. See your PC Card documentation to determine the required I/O address. (See BIOS Setup Utility on page 29 for more information) Check all I/O addresses located within the BIOS setup utility and any other installed hardware or software to make sure there are no duplications. Use the Status Indicator panel to verify the presence and condition of the batteries. (See Status Indicator Panel on page 11 for more information) If a battery is indicating a short, remove that battery and operate from another power source or replace that battery. 59 LifeBook S Series ­ Section Five Problem Possible Cause Possible Solutions You turn on your LifeBook notebook and nothing seems to happen. (continued) The battery or batteries are low. Check the Status Indicator Panel to determine the presence and condition of the batteries. (See Status Indicator Panel on page 11 for more information) Use a Power adapter to operate until a battery is charged or install a charged battery. The power adapter (AC or auto/airline) is not plugged in properly. The Power adapter (AC or auto/airline) has no power from the AC outlet, airplane seat jack, or the car's cigarette lighter. The Power adapter (AC or auto/airline) is faulty. [. . . ] Right click [Intersil PRISM Wireless LAN PCI Card], and click [Uninstall] from the menu that is displayed. Make sure that the icon has disappeared from the task tray in the lower right corner of the screen. Click [Start] -> [Settings] -> [Control Panel]. Perform the following steps. Click [PRISM 11Mbps Wireless LAN for Windows]. [. . . ]