User manual FUJITSU T3010

[. . . ] Copyright Copyright Fujitsu Computer Systems Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. [. . . ] Replace any defective AC Adapters. The AC Adapter is defective. Shutdown and Startup Problems The Suspend/Resume button does not work. The Suspend/Resume button is disabled from the Advanced submenu of the Power menu of the setup utility. You did not hold the button in long enough. There may be a conflict with the application software. The system powers up, and displays power-on information, but fails to load the operating system. The boot sequence settings of the setup utility are not compatible with your configuration. You have a secured system requiring a password to load your operating system. An error message is displayed on the screen during the Tablet PC boot sequence. Your system display won't turn on when the system is turned on or when the system has resumed. Power On Self Test (POST) has detected a problem. Enable the button from the setup utility. Hold the button longer. This may need to be a few seconds if your application is preventing the CPU from checking for button pushes. Close all applications and try the button again. Set the operating source by pressing the [F2] key while the Fujitsu logo is on screen, entering the setup utility and adjusting the source settings from the Boot menu. See "BIOS Setup Utility" on page 34. Enter the setup utility and verify the Security settings and modify them as accordingly. See "BIOS Setup Utility" on page 34. See the Power On Self Test (POST) messages to determine the meaning and severity of the problem. Not all messages are errors; some are simply status indicators. See "Power On Self Test Messages" on page 61. Check the status indicator panel to verify that the Security icon is blinking. If it is blinking, enter your password. The system may be passwordprotected. 58 Tr o ub le s ho o ti ng Problem Possible Cause Possible Solutions Your Tablet PC appears to change setup parameters when you start it. BIOS setup changes were not saved when you made them and exited the BIOS setup utility returning it to previous settings. [. . . ] IP address consists of the subnet address and the address of each computer. Subnet mask defines how many bits of IP address comprise the subnet address. The same value shall be set among computers communicating with each other. TCP/IP (Transmission Control Protocol/Internet Protocol) A standard protocol of the Internet. [. . . ]