User manual FUNAI 3913LCV

[. . . ] Follow Instructions- All operating and use instructions should be followed. Cleaning- Unplug this video product from the wall outlet before cleaning. EXCEPTION: A product that is meant for uninterrupted service and, that for some specific reason, such as the possibility of the loss of an authorization code for a CATV converter, is not intended to be unplugged by the user for cleaning or any other purpose, may exclude the reference to unplugging the appliance in the cleaning description otherwise required in item 5. Attachments- Do not use attachments not recommended by the video product manufacturer as they may cause hazards. [. . . ] If the video product has been dropped or damaged in any way. When the video product exhibits a distinct change in performance-this indicates a need for service. Replacement Parts- When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Safety Check- Upon completion of any service or repairs to this video product, ask the service technician to perform safety checks to determine that the video product is in proper operating condition. Heat- This video product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. For safety and optimum performance of your VCP: · install the VCP in a horizontal and stable position. Do not place anything directly on top of the VCP. Shield it from direct sunlight and keep it away from sources of intense heat. Avoid places with insufficient ventilation for proper heat dissipation. do not block the ventilation holes on the sides of the VCP. ⷠBe sure to push the DC cable, plug completely into the cigarette-lighter socket. ⷠDisconnect the DC cable from the cigarette-lighter socket first, before you unplug it from the VCP. ⷠYou must disconnect the DC cable from the VCP before you can use AC power. Be sure to replace the fuse on the DC cable with only the same type, 5A, 250V. With this connection, you can get better pictures and sounds when playing back a tape if your TV has A/V Input jacks. Jack of "Remote Control Sensor Wire" box (not supplied) when the VCP locates remote cargo area or behind rear seat. Instead of firing at the VCP, you can control its function by locating "Remote Control Sensor Wire" box where it is accessible to signal from remote control unit. *You can't use the remote sensor on the front panel of the VCP when this jack is occupied. If your TV does not have A/V terminals: When the VCP is in the Playback mode, your TV will receive signals from the VCP on either channel 3 or 4. To use the VCP with your TV, set the selector switch to CH3 or CH4 (which is located in the back of your VCP), whichever is not used for normal broadcasts in your area. Instead of firing at the VCP, you can control its function using remote control sensor on your TV (Funai TV). [. . . ] Only a tape recorded in the SLP mode will show a clear picture. You can change position of the noise lines on a still picture by pressing [STILL] repeatedly. ⷠAfter the VCP has been in Still mode for 5 minutes, it will stop automatically to protect the tape and the video head. If the picture begins to vibrate vertically during the still mode, stabilize the picture by pressing [TRACKING If the picture is distorted or rolling vertically, adjust the vertical hold control on your TV, if equipped. [. . . ]