User manual FUNAI 4800Z

[. . . ] Do not defeat the safety purpose of the polarized or groundingtype plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] At this time, if you press another button, this flashing stops. The power turns ON and the POWER indicator on the main unit turns green. It takes approximately 8 seconds for the screen to display after turning the power ON, but this is not a malfunction. To turn the audio mute off, either press the MUTE button again or press the VOL K / L button. â· If you press either the PREVIOUS, K, L, B or { button in a mode apart from the image adjustment mode. Press the POWER button to turn the power STANDBY. The POWER indicator on the main unit turns blue and the STANDBY indicator lights up. Each time you switch the input, the name of the selected input terminal is displayed on the screen for approximately 4 seconds. "No signal" is displayed on the screen if there is no input from the selected terminal and there is no message currently displayed on the screen for volume adjustment or the setup menu, etc. â· If there is no video signal and there has been no operation from the remote control or the buttons on the main unit for more than 15 minutes, the auto shut-off function activates and the display switches to standby mode. You cannot turn the power ON for approximately 3 seconds after the power enters the standby mode. Wide will display a 4:3 picture at a 16:9 size, with less horizontal elongation necessary to fill the screen because a little bit of the top and bottom will be cut off. Zoom will magnify the entire 4:3 picture to fill the screen, with no horizontal elongation to fill the screen, as more of the top and bottom are cut off. Use this mode to view letterboxed 4:3 picture content to get a widescreen picture. When the still mode is on, the message "Still" slowly flashes on the screen. You cannot turn the still mode on when there is no video signal or when switching between video signals. Press the STILL button again to turn the still mode off. You can also press the INPUT SELECT, DISPLAY, SLEEP, VOL K(up) / L(down), MUTE, SCREEN MODE or MENU buttons to turn the still mode off. The timer starts counting down after the message displaying the set time disappears (after approximately 4 seconds). The remaining time displayed for the sleep timer changes in steps of 1 minute. â· To change the set time, repeat the above procedure. In the setup menu, you can specify settings for picture adjustment, picture position, language, screen saver and background. [. . . ] Snowing occurring when the plasma display is connected to a cable TV system may indicate a bad cable wire or loose connection. RADIO FREQUENCY INTERFERENCE: The interference produces moving ripples or diagonal streaks and in some cases, causes loss of contrast in the picture. Lf this monitor causes a problem to Radio receivers, then take the following steps: - Keep the monitor away from Radio. - Adjust Radio antennas in order for the monitor not to receive interference. [. . . ]