User manual FUNAI 6420FD

[. . . ] will repair this SYLVANIA product, free of charge in the USA in the event of defect in materials or workmanship as follows: DURATION: PARTS: LABOR: FUNAI CORP. will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase. Certain parts are excluded from this warranty. will provide the labor without charge for a period of ninety (90) days from the date of original retail purchase. Owner's Manual FEATURES q q q q 20 INCH COLOR TELEVISION 6420FD Flat Screen Picture Tube MTS/SAP Tuner 181 Channel Selection- All VHF/UHF channels plus up to 125 cable channels. [. . . ] Infrared Sensor Window- Receives the infrared control signals from the remote control unit. CHANNEL NUMBER button- Press two digits to directly access the desired channel. Remember to press a "0" before a single digit channel. +100 button- Press to select cable channels higher than 99. MUTE button- Press the MUTE button to turn off the sound portion of the TV program. (Volume level display turns LIGHT RED from LIGHT BLUE. ) Press the MUTE button again or press the VOL(ume) v or w button to restore sound. INSTALLING THE BATTERIES 1) Slide the battery compartment cover back on the remote unit. 2) Insert 2 "AA" penlight batteries into battery compartment in the direction as indicated by the polarity (+ / -) markings. Batteries installed with incorrect polarity may damage the remote unit. 3) Replace the cover. USING AUDIO/VIDEO INPUT JACKS When you use the AUDIO/VIDEO input jacks, select "VIDEO1" or "VIDEO2" mode by pressing the INPUT SELECT button on the remote control. · To use the jacks on the back of the TV, select "VIDEO1". · To use the jacks on the front of the TV, select "VIDEO2". NOTES: · You may also select Game mode and Video2 at the same time by pressing the GAME button on the remote control. "GAME" appears on the TV screen. The TV will switch to Video2 input on the front of the TV. (See PICTURE ADJUSTMENT. ) · When you use the S-VIDEO connection, S-VIDEO jack on the rear panel is given priority over the VIDEO jack. PREPARATION FOR USE LANGUAGE SELECTION If you want to change the language of the on-screen menu, follow the procedure below. 1) Connect the power cord to a standard AC outlet. Note: If some digits appear in the corner of the screen, press the POWER button without unplugging the power cord. 2) Press the POWER button to turn on the TV. 3) Press the MENU button so that the menu display appears on the TV screen. 4) Press the CH(annel) v or w button to point to "[ENGLISH]". 5) Select "ENGLISH" or "ESPAÑOL" = Spanish by using the VOL(ume) v or w button. 6) Press the MENU button to exit the menu. PICTURE CHANNEL SET [ENGLISH]ESPAÑOL V-CHIP SET UP CAPTION [OFF] TV SOUND [MAIN] PICTURE CHANNEL SET [ENGLISH]ESPAÑOL V-CHIP SET UP CAPTION [OFF] TV SOUND [MAIN] 3) Press the VOL(ume) v button so that "ADD/DELETE" is selected. [. . . ] It could save you time and money. Poor Reception on Some Channels Different color marks on screen Remote Control Doesn't Work MAINTENANCE CABINET CLEANING q PICTURE TUBE CLEANING Wipe the picture tube of the TV with a soft cloth. Before cleaning the picture tube, disconnect the power cord. Lines or Streaks in Picture Sound OK, Picture Poor Picture OK, Sound Poor Picture Rolls Vertically No Picture or Sound Ghosts in picture Picture Distorted QUICK SERVICE CHECK LIST q Bars On Screen POSSIBLE REMEDY Picture Blurred Weak Picture No Color Wipe the front panel and other exterior surfaces of the TV with a soft cloth immersed in lukewarm water and wrung dry. Such chemicals may cause damage and discoloration to the exposed surfaces. PROBLEM Try a new channel, if OK, then possible station trouble. Is antenna connected to terminal on the back of the set? [. . . ]