User manual FUNAI EWV403A

[. . . ] EMERSON AND THE G-CLEF LOGO ARE REGISTERED TRADEMARKS OF EMERSON RADIO CORP. , PARSIPPANY, NEW JERSEY, U. S. A. RF Output Channel If channel 3 is already occupied for broadcasting, Hint 1) Set your TV to channel 4. · The RF output channel may 2) Insert a pre-recorded tape into the VCR. not change when you adjust 3) Press the PLAY button once. In this case, stop the playback, 4) After a few seconds, press the PLAY button on the VCR for 3 seconds. [. . . ] If needed, cover the hole with cellophane tape. A Note about Recycling This product's packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations. Batteries should never be thrown away Avoid the Hazards of Electrical Shock and or incinerated but disposed of in accorFire dance with your local regulations con· Do not handle the power cord with wet cerning chemical wastes. Note to the Cable TV System Installer · Do not pull on the power cord when disconnecting it from AC wall outlet. This reminder is provided to call the Grasp it by the plug. Cable TV system installer's attention to Article 820-40 of the National Electrical Moisture Condensation Warning Code, which provides guidelines for Moisture condensation may occur inside proper grounding ­ in particular, specifythe unit when it is moved from a cold ing that the cable ground shall be conplace to a warm place, or after heating a nected to the grounding system of the cold room or under conditions of high building, as close to the point of cable humidity. Do not use the VCR at least for entry as possible. CAUTION: FCC Warning TO PREVENT ELECTRIC SHOCK, This equipment may generate or use MATCH WIDE BLADE OF PLUG TO radio frequency energy. modifications to this equipment may ATTENTION: cause harmful interference unless the POUR ÉVITER LES CHOC modifications are expressly approved in ÉLECTRIQUES, INTRODUIRE LA the instruction manual. The user could LAME LA PLUS LARGE DE LA lose the authority to operate this equipFICHE DANS LA BORNE CORREment if an unauthorized change or modi- SPONDANTE DE LA PRISE ET fication is made. POUSSER JUSQU'AU FOND. Cannot go into Recording mode. Playback picture is partially noisy. · Adjust tracking control for a better picture by pressing the CHANNEL buttons. No playback picture (only sound can be heard. ) No or poor playback picture. · Head cleaning may be necessary. Refer to "Auto Head Cleaning" on page 8. · Make sure the VCR is not in the Menu mode. · Turn on the TV and set the TV to channel 3. If channel 3 is already occupied for broadcasting, change the RF output to channel 4, and change the TV channel to channel 4. (See "RF Output Channel" on page 1 for the detail. ) · Fine tune the channel reception on your TV. TV programs cannot be seen nor- · Re-check the ANT. · Press the VCR/TV button on the remote control so that the VCR/TV indicator on the VCR disappears. No VCR operation from the infrared Remote Control. · Make sure the power plug is connected to an AC outlet. [. . . ] If a streaky or snowy picCabinet Cleaning ture appears during playback, the video heads in your VCR may need to be cleaned. · Wipe the front panel and other exterior surfaces of the VCR with a soft cloth immersed 1. Please visit your local Audio/Video store and purchase a good quality VHS Video Head Cleaner. · Never use a solvent or alcohol. [. . . ]