User manual FUNAI F20LCTE

[. . . ] Read instructions-All the safety and operating instructions should be read before the appliance is operated. Retain Instructions-The safety and operating instructions should be retained for future reference. Follow Instructions-All operating and use instructions should be followed. Cleaning-Unplug TV from the wall outlet before cleaning. [. . . ] Remember to press "0" before a single digit channel. MUTE button- Press to turn off the sound (Volume level display changes LIGHT RED from LIGHT BLUE). DISPLAY button- Press to display the channel number and TV sound mode on the screen. Press it again to return to the present channel. Remove the battery compartment cover on the remote unit by sliding it while slightly twisting. Push the cover on its top side until it clicks in order to fit the cover completely to the compartment. Be sure to follow the correct polarity as indicated in the battery compartment. Do not mix different types of batteries together (e. Alkaline and Carbon-Zinc) or old batteries with fresh ones. â· If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. â· Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. And require a special converter to receive these channels. When you use the AUDIO/VIDEO input jacks, select "VIDEO1" or "VIDEO2" mode by pressing INPUT SELECT on the remote control or SELECT on the front panel on the TV. When you use the S-VIDEO connection, S-VIDEO jack is given priority over the VIDEO jack. This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. If you want to change the language of the on-screen menu, follow the procedure below. 1 Connect antenna or cable first, then connect the power cord to a standard AC outlet. Note: If some digits appear in the corner of the screen, press POWER without unplugging the power cord. In this case, please check the antenna connections, then try the auto preset again. When you press CH or after selecting "AUTO PRESET CH", the tuner will stop at the memorized channels only. The TV may memorize TV channels as CATV channels if the reception conditions are poor. If this happens, try AUTO PRESET CH action again when reception conditions are better. [. . . ] may cause scrambled or incomplete captions to appear. Broadcasters may at times use a time compression process to the actual program so that additional advertising time can be given. Since the decoder cannot read the compressed information, captions will be lost. The videotape was either an illegal copy or the tape duplicating company accidentally left out the captioning signals during the copying process. [. . . ]