User manual FUNAI F42PDME

[. . . ] Some cables here are not included with the plasma display. In order to view television, it is necessary to connect a tuner device (example: cable box, satellite box, DTV, etc. Before you can view a picture on the plasma display, you must first connect the unit to an external video source. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] â· If there is no video signal and there has been no operation from the remote control or the buttons on the main unit for more than 15 minutes, the auto shut-off function activates and the display switches to standby mode. You cannot turn the power ON for approximately 3 seconds after the power enters the standby mode. Do not turn the power to STANDBY and then ON again in a short time interval. â· Even if the power is turned to STANDBY, the main unit is in the standby mode. In order to shut the main power of the display OFF, it is necessary to remove the AC cord from the power outlet. Each time you switch the input signal, the name of the selected input terminal is displayed on the display for approximately 4 seconds. The INPUT SELECT button cycles through the input terminals in the following pattern: DISPLAY The procedure for selecting the input signal described here is for use with the remote control. However, the INPUT SELECT button on the plasma display can also be used in the same way. When switching the input signal, audio mute turns ON temporarily. â· S-VIDEO1 takes priority over the VIDEO 1 jack, as does S-VIDEO 2 over the VIDEO 2 jack. Therefore, if there is input to the VIDEO and SVIDEO terminals at the same time, the S-VIDEO signal is displayed on the screen. Any of the following display formats: 480i, 480p (progressive), 1080i and 720p (progressive) signals can be connected to the COMPONENT 2 terminal. If one of these video signals is detected, the format of the input signal is displayed after the name of the current input terminal, as in the following manner. To clear the name of the current input terminal, press the DISPLAY button again or wait for approximately 4 seconds. A "No signal" message appears if there is no video signal and there is no message currently displayed on the screen for volume adjustment or the setup menu, etc. If there continues to be no video signal for more than 10 seconds, "No signal" slowly moves around the screen. â· If there is no video signal and there has been no operation from the remote control or the buttons on the main unit for more than 15 minutes, the auto shut-off function activates and the display switches to standby mode. Each time you change the screen mode, the name of the selected mode is displayed on the screen for approximately 4 seconds. The SCREEN MODE button switches between the screen modes in the following pattern. When switching the input signal, the audio mute turns ON temporarily. â· You can only select the "Normal" and "Zoom" screen modes for 1080i and 720p video signals connected to the COMPONENT 2 terminal. By changing the aspect ratio of the screen you can select the manner in which you wish to view the picture. [. . . ] - The antenna cable of Radio should be kept away from the monitor. You can check if this monitor influences Radio receivers by turning off all other equipment other than the monitor. If you find a problem receiving Radio when using the monitor, check the instructions mentioned above. Depending on the screen contents, in rare cases this may cause vertical stripes to appear because of failure to light. [. . . ]