User manual FUNAI SRV202

[. . . ] A PURCHASE RECEIPT OR OTHER PROOF OF ORIGINAL RETAIL PURCHASE WILL BE REQUIRED TOGETHER WITH THE PRODUCT TO OBTAIN SERVICE UNDER THIS WARRANTY. . This warranty shall not be extended to any other person or transferee. This warranty is void and of no effect if any serial numbers on the product are altered, replaced, defaced, missing or if service was attempted by an unauthorized service center. This SYLVANIA Limited warranty does not apply to any the product not purchased and used in the United States. [. . . ] NOTE:You MUST PRESET channels BEFORE using CHANNEL L/M button. (See CHANNEL PRESETTING) Press to select a setting mode from the menu on the TV screen. Press to select item you want to adjust in the picture control mode. POWER button- Press to turn the TV ON and OFF. Infrared Sensor Window- Receives the infrared control signals from the remote control unit. 16 9. CHANNEL NUMBER buttons- Press two digits to directly access the desired channel. Remember to press a "0" before a single digit channel. +100 button- Press to select cable channels which are equal or greater than number 100. 10. MUTE button- Press the MUTE button to turn off the sound portion of the TV program. (Volume level display turns LIGHT RED from LIGHT BLUE. ) Press the MUTE button again or press the VOL(ume) L or M button to restore sound. 11. CHANNEL RETURN button- Press this button to go back to the previously viewed channel. 2) Press the MENU button so that the menu display appears PICTURE CHANNEL SET on the TV screen. [ENGLISH]ESPAÑOL 3) Press the CH(annel) L or M button to point to "CHANNEL SET". V-CHIP SET UP CAPTION [OFF] Then, press the VOL(ume) L button. 4) Press the CH(annel) L or M button to point to "AUTO MEMO". PICTURE The tuner scans and memorizes all active channels in your area. CHANNEL SET [ENGLISH]ESPAÑOL G The TV distinguishes between standard TV channels and cable channels. V-CHIP SET UP CAPTION [OFF] G When AUTO MEMO action is completed, the lowest memorized channel reappears on the screen. G When you press the CH(annel) L or M button after selecting AUTO ADD/DELETE MEMO, the tuner will stop at the memorized channels only. AUTO MEMO G The TV may recognize TV channels to be CATV channels STEREO [OFF] by the receiving conditions. In this case, try AUTO MEMO action again in the fine receiving conditions. [ADD/DELETE FUNCTION] 1) Press the MENU button so that the menu display appears on the TV screen. 2) Press the CH(annel) L or M button to point to "CHANNEL SET". [. . . ] Then, press the VOL(ume) button to select [BLOCK] or [VIEW]. Note: When you select [TV-MA], "D" does not appear on the TV screen. The sub-ratings which set to [BLOCK] appears next to the rating category in the TV RATING menu. 5 Press the MENU button to exit the menu. TV-PG D L S V [BLOC [BLOC [BLOC [BLOC [BLOC TV-Y [VIEW ) [VIEW TV-Y7 ( [BLOC TV-G TV-PG (DLSV) [BLOC TV-14 (DLSV) [BLOC TV-MA ( LSV) [BLOC TROUBLESHOOTING GUIDE Sometimes a performance problem can be easily solved by checking seemingly apparent but often overlooked possibilities. [. . . ]