User manual FUNAI SSC130

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The caution marking is located on the rear of the cabinet. IMPORTANT SAFEGUARDS 1. Read instructions-All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions-The safety and operating instructions should be retained for future reference. 3. Heed Warnings-All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow Instructions-All operating and use instructions should be followed. [. . . ] In this case, "PROTECTED PROGRAM by . . . " message appears on the TV screen. To block ratings, follow the steps below. · Programming may be rated by the Motion Picture Association of America (MPAA) or according to the Television Parental Guidelines. In order to block any inappropriate programming, set your limits in both places (MPAA RATING and TV RATING). Selection TV-Y TV-Y7 TV-G TV-PG TV-14 TV-MA Rating Category Explanations Appropriate for all children Appropriate for children seven and older General Audience Parental Guidance suggested. Unsuitable for children under 14 Mature audience only TV RATING SET UP Make sure . . . · TV/VCR power must be turned on. 1 Select "V-CHIP SET UP" ­MENU­ TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK CHANNEL SET UP USER'S SET UP B V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN TIME SEARCH INDEX SEARCH Press the MENU button on the remote control. Press the PLAY/K or STOP/L button to point to "V-CHIP SET UP". Then, press the F. FWD/B button. 2 Select "TV RATING" ­ V-CHIP SET UP ­ B TV RATING MPAA RATING Press the PLAY/K or STOP/L button to point to "TV RATING". Then, press the F. FWD/B button. 3 Select your desired item B TV­Y TV­Y7 ( TV­G TV­PG ( TV­14 ( TV­MA ( [VIEW] [VIEW] [VIEW] [VIEW] [VIEW] [VIEW] Press the PLAY/K or STOP/L button to point to your desired item. Then, press the F. FWD/B button to select [BLOCK] or [VIEW]. When you select TV-Y7, TV-PG, TV-14, or TV-MA and you press the F. FWD/B button, the sub-ratings will appear on the TV screen. If you select the rating category (example: TV-PG) and turn it [BLOCK] or [VIEW], the sub-ratings (example: V for Violence) will turn [BLOCK] or [VIEW] automatically. NOTE: If it is left in the Slow mode for more than five minutes, the TV/VCR will automatically go into the Stop mode. 1 Insert a prerecorded tape If the erase-protection tab has been removed, the TV/VCR will start playback automatically. 2 To begin playback PICTURE SEARCH PLAY B Press the PLAY button. 3 To stop playback STOP Press the STOP button when playback is completed. This feature is very useful in finding or skipping over a particular scene on a tape. 1)You may view a video tape at a high speed in either a forward or reverse direction by pressing the F. FWD or REW button. (in the SP / LP / SLP modes) 2)Press it again and the TV/VCR will now search in super high speed. (in the LP / SLP modes only) NOTE: Tapes recorded in the SP or LP mode will display a noise bar on the TV screen and the picture may revert to Black and White. 3)Press the PLAY button to return to normal speed. TRACKING ADJUSTMENT · Tracking adjustment will be set automatically (Digital Tracking function) when you start playback. · However when playing pre-recorded tapes or tapes recorded on units other than your own, noise lines (black and white streaks) may appear on the playback picture. If this occurs, you can adjust the tracking control manually by pressing the CHANNEL K or L button until the streaks disappear. To return to the DTR function, stop the tape once and start playback again. · You can reduce the noise lines by pressing the CHANNEL K or L button in slow mode, too. Tracking adjustment in Slow mode will not be set automatically. NOTE: · In Still mode, press the SLOW button and press the CHANNEL K or L button until streaks disappear. [. . . ] (Ejemplo: 1 - 01) Luego, pulse el botón F. FWD/B. 5) Pulse el botón PLAY/K o STOP/L hasta que aparezca el año deseado. (Ejemplo: 2001) Luego, pulse el botón F. FWD/B. 6) Pulse el botón PLAY/K o STOP/L hasta que aparezca la hora deseada. [. . . ]