User manual FUNAI WF2703

[. . . ] FUNAI CORPORATION LIMITED WARRANTY FUNAI CORP. will repair this product, free of charge in the USA in the event of defect in materials or workmanship as follows: DURATION: PARTS: LABOR: FUNAI CORP. will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase. Certain parts are excluded from this warranty. [. . . ] For example, pressing the CHANNEL RETURN button once will change channel display from CH 3 (present channel) to CH 10 (previously viewed channel), and pressing it a second time will return from CH 10 to CH 3. 12. DISPLAY button- Press to display the channel number on the screen. If you press it again, the channel number will disappear. 13. SLEEP button- Press the SLEEP button to display the sleep timer and start the function. The shut off time can be determined by the number of times you press the button. (0, 10, 20, 30, . . 90, 0 minutes) 14. GAME button- Press to set the Game mode and external input mode at the same time. Press the GAME button again to exit this mode. IN jack- Connect to an antenna, cable system, or satellite system. 16. AC cord- Connect to a standard AC outlet (120V/60Hz). NOTE: Unwrap the AC cord completely from the backcover before plugging the cord into an AC outlet. INSTALLING THE BATTERIES 1) Slide the battery compartment cover back on the remote unit. 2) Insert 2 "AA" penlight batteries into battery compartment in the direction as indicated by the polarity (+ / -) markings. Batteries installed with incorrect polarity may damage the remote unit. 3) Replace the cover. PREPARATION FOR USE LANGUAGE SELECTION If you want to change the language of the on-screen menu, follow the procedure below. 1) Connect the power cord to a standard AC outlet. Note: If some digits appear in the corner of the screen, press the POWER button without unplugging the power cord. 2) Press the POWER button to turn on the TV. 3) Press the MENU button so that the menu display appears on the TV screen. 4) Press the CH(annel) or button to point to "[ENGLISH]". 5) Select "ENGLISH" or "ESPAÑOL" = Spanish by using the VOL(ume) or button. 6) Press the MENU button to exit the menu. PICTURE CHANNEL SET [ENGLISH]ESPAÑOL V-CHIP SET UP CAPTION [OFF] PICTURE CHANNEL SET [ENGLISH]ESPAÑOL V-CHIP SET UP CAPTION [OFF] CHANNEL PRESETTING NOTE:You MUST PRESET channels BEFORE using CHANNEL or button. To preset a channel or to change a preset channel, follow the procedure below. 1) Press the POWER button to turn on the TV. PICTURE 2) Press the MENU button so that the menu display appears CHANNEL SET on the TV screen. [. . . ] Before cleaning the picture tube, disconnect the power cord. Remote Control Doesn't Work Lines or Streaks in Picture Sound OK, Picture Poor Picture OK, Sound Poor Picture Rolls Vertically Ghosts in picture Picture Distorted QUICK SERVICE CHECK LIST No Picture or Sound Bars On Screen Picture Blurred Weak Picture No Color Wipe the front panel and other exterior surfaces of the TV with a soft cloth immersed in lukewarm water and wrung dry. Do not spray insecticide liquid near the TV. Such chemicals may cause damage and discoloration to the exposed surfaces. PROBLEM POSSIBLE REMEDY SUPPLIED ACCESSORIES Remote control unit (N0132UD/N0108UD) Batteries ("AA" x 2) Owner's Manual Try a new channel, if OK, then possible station trouble. Is antenna connected to terminal on the back of the set? [. . . ]