User manual FURMAN ELITE15

[. . . ] With Furman's exclusive Linear Filtering Technology, televisions, projectors, DVD players, amplifiers, and processors are fed linearly-filtered AC power. This dramatically reduces noise, ensuring consistent peak operation regardless of load conditions or the time of day. For the first time, you will see and hear your theater or audio system as it should be ­ uncompromised. Another critical feature is our exclusive Series Multi-Stage Protection Plus. [. . . ] Turn it clockwise to increase brightness; turn it counter-clockwise to decrease brightness. When the lights tubes are fully inserted flush to the front panel, the light circuit is turned off via an internal micro-switch. Whether the light tubes are retracted or nearly flush with the front panel, there will be no appreciable heat regardless of dimmer setting due to the efficiency of our full light spectrum LED's. AC Voltage Meter Your Elite-15 contains a combination precision incoming AC voltage meter. The meter continuously monitors and displays the incoming AC voltage (+/- 1VAC typically). Soft Start - Continuous Use When power is first applied to the Elite-15, (the front panel breaker- power toggle must be switched to the "on" position) the Soft Start feature is activated. There is an audible "clack" when the Elite-15 is first turned on or off. This sound is produced by the Soft Start circuit's 30 Amp relay engaging or disengaging. There is Connections: AC Cable Routing The Elite-15's male Edison AC cord must be connected to an appropriate socket (see current rating recommendation above). Connecting Components to the Digital Video Component AC Outlet Banks The Elite-15's four "Digital - Video Component AC Outlets" should be employed for critical 3 ELITE 15 OWNER'S MANUAL virtually nothing in the Elite-15's construction, design, or componentry to wear over the life time of the product, and there is no power draw from your electric service meter aside from the LED power indicator, lamps, and relay circuits. For this reason the Elite-15 may be left with its power engaged permanently at a cost of pennies per month. Transient Voltage Surge Suppression device to absorb without some degree of damage. In the rare instance that this occurs, the blue LED located in the center of the front panel will dim, even though AC power is present at the unit's outputs. If this happens, some level of protection from voltage surges will remain, but the Furman's clamping voltage rating will be compromised. The unit must be returned to Furman Sound, or an authorized Furman Service center for repair. NOTE: If the mains power is above the high cutoff voltage and has caused the unit to remove power from its outlets, it cannot restore power without the operator manually turning the unit off, then on again. Avoid turning the unit back on, without first checking the source of the problem, and perhaps changing the AC source. Telco ­ Satellite ­ Cable Transient Voltage Surge Suppressors The Elite-15 features transient voltage surge suppression for both standard telephone lines, as well as cable or satellite lines utilizing standard coaxial connectors. As these surge suppressors are in-line, they will require an additional cable to connect from their output to the control device requiring protection. All in-line surge suppressors feature our exclusive ground contamination free technology. This aids in eliminating audio buzzing, and the video hum-bars that can result from typical in-line suppressors. Further, our cable and satellite suppressors are TIVO friendly as well as HD-Digital Television ready. [. . . ] If any part of this Limited Warranty is determined to be void or illegal, the remainder shall remain in full force and effect. Warranty claims should be accompanied by a copy of the original purchase invoice showing the date of purchase (if a Warranty Registration Card was mailed in at the time of purchase or if the product was registered on-line, this is not necessary). Before returning any equipment for repair, please be sure it is adequately packed and cushioned against damage in shipment, and that it is insured. 6 ELITE 15 OWNER'S MANUAL Elite 15 SPECIFICATIONS AC Current Capacity: Input - 15 Amp capacity required Output - 15 Amps RMS (maximum, all outlets combined - continuous) Linear Noise Attenuation: Transverse (Differential) Mode: >40 dB from 10Khz. [. . . ]