User manual FURMAN HA6AB

[. . . ] HA-6AB / HA-6ABE Manual 1 HA-6AB / HA-6ABE Manual Important Note: To obtain best results from this Furman Sound electronic product, please be sure to read this manual carefully before using it. Please fill out and return the Warranty Registration Card immediately to obtain full protection under the terms of the Limited Warranty, in case your ownership documents are lost. Please verify that the serial number shown on the Warranty Card matches the serial number on your unit. INTRODUCTION Congratulations on your purchase of a Furman Sound HA-6AB. You have chosen the Automatically switches to mono most versatile headphone amplifier available. [. . . ] The Input Level control is stereo; it affects both left and right channels simultaneously. triggered, the lights will stay lit for a minimum of 50 milliseconds so they can be easily seen, even if the actual duration of the overload is much shorter. HEADPHONE JACKS / VOLUME CONTROLS: Any type of headphones, wired with a standard 1/4" stereo phone plug, may be used successfully. All six outputs receive the same stereo signal. They differ only in the individual volume settings. SPEAKER-A BUTTON: Depressing this button turns on the speakers connected to the SIGNAL PRESENT LIGHTS: These yellow LED's SPEAKER-A banana jacks on the rear panel, and turn on whenever a signal exceeding 125 mil- simultaneously turns off the signal to all the front livolts RMS (40 dB below full power) is present panel headphone outputs. They will increase in SPEAKER-B BUTTON: Depressing this button brightness as the signal strength increases. This turns on whatever is plugged into the SPEAKERfeature is very useful and can provide a clue to B SATELLITE/REMOTE XLR connector on the where the fault may lie if the expected program rear panel. This will be either a pair of speakers is not heard at the listening stations. Therefore, OVERLOAD LIGHTS: These LED's glow red to indicate an overload in the HA-6AB. If the LED lights up, either the drive level to the unit should be reduced, or the setting of the Input Level control should be reduced until the LED remains off. The lights turn on when the signal level at either output approaches . 5 to 1 dB of clipping. Once leave this button depressed when using Remote Stations. Depressing it does not turn off the front panel headphone outputs. See the section on the Rear Panel for speaker wiring. POWER LIGHT: Glows red when unit is receiving power and the ON-OFF SWITCH is in the ON position. 6 HA-6AB / HA-6ABE Manual REAR PANEL ON-OFF SWITCH: This switch turns the HA-6AB on and off. For convenience, it is recommended that the HA-6AB and any other rack-mount equipment be powered through a switchable outlet box, such as the Furman Sound PL-8 or PL-PLUS Power Conditioner and Light Module. The PL Series provides an easy way to power up the whole rack with one front-panel switch, and provides discreet illumination on dark stages and studios as well. Microphones and/or instrument pickups may not have strong enough outputs to drive the 120 VAC ON 50/60 Hz 130 Watts OFF LIFT LEFT RIGHT RISK OF ELECTRIC SHOCK. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN AND MOISTURE. RISQUE DE CHOC ELECTRIQUE -- NE PAS OUVRIR ® ® HEADPHONE/ AMPLIFIER MONITOR AVIS: SATELLITE / REMOTE LISTED 7Z37 PROFESSIONAL AUDIO EQUIPMENT BALANCED INPUT BALANCED INPUT GROUND SPEAKER B SPEAKER A CAUTION! LEFT INPUT RIGHT INPUT 7 HA-6AB / HA-6ABE Manual HA-6AB directly without first being preamplified. The 1/4" phone inputs are stereo jacks (tip-ringsleeve) wired for a balanced input. [. . . ] Manufacturer shall not have any other THREE YEAR LIMITED WARRANTY Furman Sound, Inc. , having its principal place of business at 1997 South McDowell Blvd. , Petaluma, CA 94954 ("Manufacturer") warrants its HA-6AB (the "Product") as follows: Manufacturer warrants to the original Purchaser of the Product that the Product sold hereunder will be free from defects in material and workmanship for a period of three years from the date of purchase. The Purchaser of the product is allowed fifteen days from the date of purchase to complete warranty registration by mail or online at the Furman website. If the Product does not conform to this Limited Warranty during the warranty period (as herein above specified), Purchaser shall notify Manufacturer in writing of the claimed defects. If the defects are of such type and nature as to be covered by this warranty, Manufacturer shall authorize Purchaser to return the Product to the Furman factory or to an authorized Furman repair location. [. . . ]