User manual FURMAN HR2 INSTALL GUIDE

[. . . ] Petaluma, California 94954-6919 USA Phone: 707-763-1010 · Fax: 707-763-1310 www. furmansound. com · E-mail: info@furmansound. com ily attach with a thumbscrew to any microphone stand. Each HR2 has two stereo volume controls and two headphone jacks, to accommodate two listeners. There are also two XLR connectors, one male and one female, for use in daisy-chaining units together. [. . . ] If this mix is mono, con nect it to the Left Input. The HA-6A will then automatically be in mono mode, so that the mix can be heard with both ears (or both speakers, if used). In many situations, it may be sufficient to plug all headphones directly into the HA-6A. However, in a larger studio, or when each musician must have easy access to his or her headphone volume control, it is more practical to use several HR-2 Remote Stations at strategic locations around the room. In this case, the HA-6A (or the stereo power amplifier substituting for it) would most likely be installed in the control room. The HR-2 Remote Stations connect in "daisy chain" fashion to the SPEAKER B-SATELLITE/REMOTE output on the rear panel of the HA-6A. This output is a male 3-pin XLR connector, so that ordinary microphone cables can be used. The HA-6A connects to the first HR-2 box; another mic cable connects the first HR-2 to the second HR-2; a third mic cable connects the second HR-2 to the third HR-2; and so on. If low impedance headphones are used, up to twelve HR-2's may be chained together. If medium or high impedance headphones are used, 25 or more Remote Stations may be chained. The HR-2 Remote Stations are compact boxes which eas4-9925 Furman Sound, Inc. , having its principal place of business at 1997 South McDowell Blvd. , Petaluma, CA 94954 ("Manufacturer") warrants its HR-2 (the "Product") as follows: Manufacturer warrants to the original Purchaser of the Product that the Product sold hereunder will be free from defects in material and workmanship for a period of three years from the date of purchase. The Purchaser of the product is allowed fifteen days from the date of purchase to complete warranty registration by mail or on-line at the Furman website. If the Product does not conform to this Limited Warranty during the warranty period (as herein above specified), Purchaser shall notify Manufacturer in writing of the claimed defects. If the defects are of such type and nature as to be covered by this warranty, Manufacturer shall authorize Purchaser to return the Product to the Furman factory or to an authorized Furman repair location. Warranty claims should be accompanied by a copy of the original purchase invoice showing the purchase date; this is not necessary if the Warranty Registration was completed either via the mailed in warranty card or on-line website registration. Shipping charges to the Furman factory or to an authorized repair location must be prepaid by the Purchaser of the product. [. . . ] This Limited Warranty states the entire obligation of Manufacturer with respect to the Product. If any part of this Limited Warranty is determined to be void or illegal, the remainder shall remain in full force and effect. NOTE: All equipment being returned for repair must have a Return Authorization (R/A) Number. [. . . ]