User manual FURMAN PM8 II

[. . . ] SERIES II 15 AMP PowER CondItIonERS SERIES II 15 AMP PowER CondItIonERS Furman Series II Features · · · · · SMP+ with extreme voltage shutdown LiFT (Linear Filtering Technology) with zero ground contamination Eight rear panel outlets and one front panel outlet 15 amp rating, with circuit breaker Three year limited warranty PL-8 Series II Additional Features · · Two retractable, long-life, low-heat LED light fixtures with dimmer control for rack illumination BNC connector on the rear panel allows you to attach any standard (12VAC 0. 5 amp) gooseneck lamp to illuminate the rear of your rack PL-PLUS Series II Additional Features · · · Two retractable, long-life, low-heat LED light fixtures with dimmer control for rack illumination BNC connector on the rear panel allows you to attach any standard (12VAC 0. 5 amp) gooseneck lamp to illuminate the rear of your rack Front panel meter to display incoming line voltage ranging from 90 to 128 volts (D version has a digital meter instead of LED's) PL-PLUS d Series II Additional Features · · · Two retractable, long-life, low-heat LED light fixtures with dimmer control for rack illumination BNC connector on the rear panel allows you to attach any standard (12VAC 0. 5 amp) gooseneck lamp to illuminate the rear of your rack Laboratory precision Digital Voltmeter displays incoming line voltage (+/- 1 VAC) PM-8 Series II Additional Features · · · Laboratory precision Digital Voltmeter displays incoming line voltage (+/- 1 VAC) True RMS Current Meter displays power draw (+/- 0. 5 amp) BNC connector on the rear panel allows you to attach any standard (12VAC 0. 5 amp) gooseneck lamp to illuminate the rear of your rack 1 SERIES II 15 AMP PowER CondItIonERS INTRODUCTION Thank you for purchasing a Furman Series II Power Conditioner, and congratulations on your choice. The Series II power conditioners feature Furman's revolutionary Series MultiStage Protection Plus (SMP+) circuit, as well as our exclusive Linear Filtering Technology (LiFT). Together, these technologies comprise what is, without question, the world's most advanced and comprehensive transient voltage surge suppressor / conditioner. trusted over-voltage circuitry protects against all too frequent accidental connections to 208 or 240 VAC, by shutting off the incoming power until the over voltage condition is corrected. [For E versions: Furman's SMP+ clamps at 376 VpK, (266 VAC RMS. )] LiFT (Linear Filtering Technology) Unfortunately, traditional AC filter - conditioners have been designed for unrealistic laboratory conditions. [. . . ] The normal range voltages voltage in 1-volt steps, and a true R. M. S. are indicated in green, with moderately and current meter that measures the AC power extremely high or low voltages in yellow and red respectively. The voltmeter's accuracy is ±2 draw within 0. 5 amp. It can easily be re-calibrated, if necessary. jack accepts any standard (12VAC 0. 5 amp) gooseneck lamp for rear rack illumination. (E- versions 180 ­ 256 VAC in 4 volt steps / Jversions 80 - 118 VAC in 2 volt steps) The PL-Plus II has a master switch for all outlets that glows red when the power is on. The front-panel circuit breaker can be quickly The PM-8 II has a master switch for the rear outlets that glows red when the power is on. The front-panel circuit breaker can be quickly and easily reset should the unit be overloaded. The PM-8 II also features a 10 foot, 14 gauge 4 SERIES II 15 AMP PowER CondItIonERS heavy-duty power cable. O P E R AT I O N Retractable Rack Lights, Rear Panel Lamp and dimmer Control: The PL-8 II, PL-Plus, and PL-Plus D II utilize a dimmer control for the two retractable front panel light tubes. The dimmer knob controls the brightness of both light fixtures. Turn it clockwise to increase brightness; turn it counterclockwise to decrease brightness. When the lights are not in use, we recommend turning the dimmer fully counterclockwise to maximize the life of the LED's, however, this is not absolutely necessary. Whether the light tubes are retracted or flush with the front panel, there will be no appreciable heat regardless of dimmer setting due to the efficiency of our full light spectrum LED's. All Series II units feature a rear rack BNC socket which will accept any 12 VAC (0. 5A) gooseneck lamp assembly, (such as the Furman GN-LED or GN-I). Simply slide the BNC plug over the socket and rotate clockwise until the connector snaps into the locked position. The rear rack lamp can be powered on or Mains Vltg. 80-90 90-104 106-108 110-120 122-124 126-128 130-140 Above 140 5 off with the rear light power switch located on the far left of the front panel. The Series II's front panel LED lamps must be replaced by qualified Furman service personnel. Multi-Segment LEd voltmeter: (PL-Plus II only) This three-color, 20-LED bargraph is an accurate, self checking AC voltmeter that continually measures normal voltages. The meter reads from 90 to 128 volts in 2 volt increments (PL-PLUS E II: 180 to 256 volts, in 4 volt increments). The normal range voltages are indicated in green, with moderate and extremely high or low voltages in yellow and red respectively. The voltmeter provides three special flashing patterns to indicate abnormal conditions. [. . . ] Return shipping charges back to Purchaser will be paid by Manufacturer THE FOREGOING IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Manufacturer does not warrant against damages or defects arising out of improper or abnormal use of handling of the Product; against defects or damages arising from improper installation, against defects in products or components not manufactured by Manufacturer, or against damages resulting from such non-Manufacturer made products or components. This warranty shall be cancelable by Manufacturer at its sole discretion if the product is modified in any way without written authorization from Furman Sound. This warranty also does not apply to Products upon which repairs have been affected or attempted by persons other than pursuant to written authorization by Manufacturer. [. . . ]