User manual FURMAN PST6

[. . . ] Please read and observe all safety and operating instructions before installing your Power Station-6 (PST-6). Retain these instructions for future reference. Your PST-6 should not be used near water ­ for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, etc. Do not place your PST-6 near heat sources such as radiators, heat registers, stoves or other appliances that produce heat. [. . . ] Further, our cable and satellite suppressors are TIVO friendly as well as HD-Digital Television ready. Both DC carrier signals as well as high bandwidth signals can pass through our 4 circuit. In fact the bandwidth is less than 0. 1dB loss at 1GHz!To connect your cabling to these in-line protectors, simply follow the in and out indications marked next to the Telco, and Cable / Satellite connectors. Note: It is not possible to make an in-line cable / satellite protector "maintenance-free. " Under extreme conditions, it is possible that the surge suppression in one of these devices could sacrifice itself after a catastrophic event. If the telephone, cable or satellite signal will no longer pass through our protector, please send your Power Station to Furman for servicing. To test this, simply disconnect the incoming and out going cable from the PST-6. Connect the incoming connector to the component that formerly received the out going connector, thus by-passing the in-line protection. If the signal is present (but not when used with the PST-6) then the protection circuit is damaged (assuming it worked properly before the storm or catastrophic event). Circuit Breaker If the PST-6 is connected to an AC outlet where sufficient voltage is present, the unit should operate properly with the protection OK indicator lit, after the main power switch is turned to the on position. If the unit still does not function under these conditions check the circuit breaker button!It is the round black button adjacent to the incoming AC cord. If the circuit breaker trips immediately, there may be too great of a current load placed upon it. Simply disconnect one 5 product at a time until this no longer happens. If the breaker trips with no components connected, there may be a wiring defect that requires Furman service. Indicators Protection OK Indicator: Although Furman's Ground Contamination Free Surge Suppression rarely requires servicing, nature has a way of occasionally creating electrical forces that are beyond the capabilities of any transient voltage surge suppressor device to absorb without some degree of damage. In the instance that this occurs, the blue "Protection OK" LED indicator will turn off. If this happens, Furman's surge suppression circuit is compromised. The unit must be returned to Furman Sound, or an authorized Furman Service Center for repair. Mounting If the Power Station needs to be mounted to the inside panel of a rack or hung from a wall, a convenient crossed oval cutout is provided on the unit's bottom panel. 6 pan head screw can be used in the same way a picture is hung from a wall. Simply measure the centers on the bottom of your Power Station. This will be the distance from the two mounting holes drilled into your wall, rack or cabinet surface. Once the screw is fastened flush with the surface, back it out approximately ½". [. . . ] Under no circumstances, whether based on this Limited Warranty or otherwise, shall Manufacturer be liable for incidental, special, or consequential damages. Manufacturer's employees or representatives' ORAL OR OTHER WRITTEN STATEMENTS DO NOT CONSTITUTE WARRANTIES, shall not be relied upon by Purchaser, and are not a part of the contract for sale or this limited warranty. This Limited Warranty states the entire obligation of Manufacturer with respect to the Product. If any part of this Limited Warranty is determined to be void or illegal, the remainder shall remain in full force and effect. 8 Service All equipment being returned for repair must have a Return Authorization (R/A) Number. [. . . ]