User manual FURUNO 1623

[. . . ] MARINE RADAR MODEL 1623 Your Local Agent/Dealer 9-52 Ashihara-cho, Nishinomiya, Japan Telephone : Telefax : 0798-65-2111 0798-65-4200 All rights reserved. Printed in Japan FIRST EDITION : OCT. OME-35100 ( DAMI ) MODEL1623 *00080939200* *00080939200* *00080939200* *OME35100A00* *OME35100A00* *OME35100A00* TABLE OF CONTENTS FOREWORD. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii SYSTEM CONFIGURATION. . . . . . . . . . . . . . . . . . . . iv EQUIPMENT LISTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press the [MENU/ESC] key to close the menu. INT REJECTION LOW * P ECHO STRETCH : LOW FTC : OFF NOISE REJECTION: LOW (1/3) [MENU/ESC] : Exit. User menu, page 1 2. Press or to choose the item you wish to use. Press and hold down the [PROG] key (about three seconds) until you hear a beep. The "P" moves to the item selected. Press the [MENU/ESC] key to close the menu. 1. 26 PROG Key The [PROG] key acts as a menu shortcut key. You may use any User menu item except "TRIPLOG RESET?" and "SYSTEM MENU. " 1. 27 Outputting Target Position to a Plotter If the radar is interfaced with a plotter, you can output target position to the plotter, and show that position on the plotter's screen with the target mark (X). This function requires position and heading data. Use the cursor pad to place the cursor on a target. Press the [MARK] key to show the Mark menu. MARK MENU [GAIN] : EBL [ALARM] : VRM [MARK] : TLL OUTPUT Using the PROG key 1. The options window corresponding to the item programmed appears. In the example below the echo stretch options window is shown. ECHO STRETCH OFF LOW HIGH Echo stretch options window 2. Press or to choose appropriate option. Press the [MENU/ESC] key to close the options window. Mark menu 3. Press the [MARK] key again to output cursor position. Press the [MENU/ESC] key to close the menu. Programming the PROG key 1. Press the [MENU/ESC] key to open the User menu. "P" marks the current function of the [PROG] key. 13 1. OPERATION 1. 28 Turning Navigation Data On/Off Navigation data appears on the bottom half of the screen as in the illustration below. You may turn the navigation data display on or off as shown below. Note: When the nav data is turned on with shift or zoom active, zoom or shift is cancelled. Press the [MENU/ESC] key to close the menu. 2. 0 3. Press the [MENU/ESC] key to close the window. [. . . ] Press the [MENU/ESC] key to return to the installation menu to complete the procedure below, or shut off the power. Timing adjustment Sweep timing differs with respect to the length of the antenna cable. Adjust sweep timing to prevent pushing or pulling of the target as illustrated below and placement of targets at incorrect ranges. 28 3. INSTALLATION NMEA port setup, GPS WAAS setup The NMEA port can function as an input port or input/output port. If you are using the GP-320B, turn on the GPS WAAS feature. [. . . ]