User manual FURUNO 1715

[. . . ] MARINE RADAR MODEL 1715 Your Local Agent/Dealer 9-52 Ashihara-cho, Nishinomiya, Japan Telephone : Telefax : 0798-65-2111 0798-65-4200 All rights reserved. Printed in Japan FIRST EDITION : . 0000 PUB. No. OME-35140 ( ) MODEL1715 *00014791100* *00014791100* *00014791100* *OME35140Z00* *OME35140Z00* *OME35140Z00* TABLE OF CONTENTS SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . ii FOREWORD. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii SYSTEM CONFIGURATION. . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press or to choose DAY or NIGHT as appropriate. Press the [MENU/ESC] key to close the menu. ECHO STRETCH OFF LOW HIGH Echo stretch options window 2. Press or to choose appropriate option. Press the [MENU/ESC] key to close the options window. Programming the PROG key 1. Press the [MENU/ESC] key to open the User menu. "P" marks the current function of the [PROG] key. INT REJECTION LOW ECHO STRETCH : LOW FTC : OFF NOISE REJECTION: LOW (1/3) 1. 25 Resetting Distance Run You may reset distance run to zero as below. You need a navigator or speed log to display distance run. Press the [MENU/ESC] key to open the User menu. Press or to choose "TRIPLOG RESET?" from page 3. Press to choose YES to reset distance run to zero. Press the [MENU/ESC] key to close the menu. * P [MENU/ESC] : Exit. User menu, page 1 2. Press or to choose the item you wish to use. Press and hold down the [PROG] key (about three seconds) until you hear a beep and the "P" moves to the item selected. Press the [MENU/ESC] key to close the menu. 1. 26 PROG Key The [PROG] key acts as a shortcut key. You may use any User menu item except "TRIPLOG RESET?" and "SYSTEM MENU. " 1. 27 Outputting Target Position to a Plotter If the radar is interfaced with a plotter, you can output a radar target's latitude and longitude position to the plotter, and show that position on the plotter's screen, with the target mark (X). This function requires position and heading data. Use the cursor pad to place the cursor on a target. Press the [TLL] key to output the target's L/L position. Using the PROG key 1. The options window corresponding to the item programmed appears. In the example at the top of the next page the echo stretch options window is shown. 13 1. OPERATION 1. 28 Turning Navigation Data On/Off Navigation data appears on the bottom half of the screen as in the illustration below. You may turn the navigation data display on or off as shown below. [. . . ] While in the developmental stage choose message type 02. Change to message type 00 when WAAS becomes fully operational. Turn off the power. Improper and correct sweep timings 1. Transmit on a range between 0. 125 and 0. 5 nm and adjust the sensitivity and A/C SEA. [. . . ]