User manual FURUNO 1954C-BB Operators Manual

[. . . ] MODEL 1824C-BB/1834C-BB/1934C-BB/1944C-BB/1954C-BB, GD-1920C-BB OPERATOR'S MANUAL OPERATOR'S MANUAL Marine Radar MODEL 1824C-BB/ 1834C-BB/1934C-BB/ 1944C-BB/1954C-BB Color Video Plotter GD-1920C-BB (Elemental Chlorine Free) The paper used in this manual is elemental chlorine free. C Your Local Agent/Dealer 9-52 Ashihara-cho, Nishinomiya 662-8580, JAPAN Telephone : +81-(0)798-65-2111 Fax : +81-(0)798-65-4200 VX2 FIRST EDITION : JAN. 2005 All rights reserved. Printed in Japan Pub. OME-35490 ( DAMI ) M1804C-BB, GD1920C-BB http://www. furuno. co. jp/ SAFETY INSTRUCTIONS WARNING ELECTRICAL SHOCK HAZARD Do not open the equipment. Only qualified personnel should work inside the equipment. [. . . ] To erase last-entered quick point (waypoint), press the D: ERASE LST QP (D: ERASE LST WP) soft key. Repeat steps 3 and 4 to complete the route. A solid light-blue line with arrows connects between own ship and the first point and all other points are connected with a green dashed line with arrows. Arrows on the line show the direction to follow to get to your destination. Quick points are numbered in sequential order from QP<01> and are saved to the waypoint list. Range and bearing from own ship to the first destination appear at the top of screen. The quick points are saved as a route, under the name "Q>RTE" (Quick Route). 3. 10. 2 Navigating to waypoints Selecting a waypoint from the plotter display 1. Operate the Trackball to select a waypoint. Note: GOTO method should be selected to "1 POINT" on the PLOTTER SETUP menu. Selecting a waypoint from the waypoint list 1. Press the A: WAYPOINTS soft key to open the waypoint menu. Press the A: LOCAL LIST or B: ALPHANUMERIC LIST soft key as desired. Use the Trackball to select a waypoint. 3-40 3. Press the A: GOTO soft key, and the plotter display appears. For either of the above methods, a solid light-blue line with arrows runs between waypoint selected and own ship's position. Arrows on the line show the direction to follow to get to the waypoint. Waypoint data appears at the top of screen. Selecting an external waypoint You can select a waypoint (or route) entered at an external plotter connected with NMEA cable. Press the MENU key, B: PLOTTER SETUP soft key to show the PLOTTER SETUP menu. Press the C: ENTER soft key or ENTER knob to show the QP window. QP EXT WPT (RMB) INTERNAL QP window 4. On a connected external plotter, set a waypoint (or route) as the destination. Selected waypoint (route) appears on the NavNet plotter screen. [. . . ] 3-18 erasing all own ship's. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-23 erasing all targets'. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-23 erasing own ship's by area . . . . . . . . . . . . . . . . . . . 3-22 erasing own ship's by color. . . . . . . . . . . . . . . . . . . [. . . ]