User manual FURUNO NAVPILOT 500 Operators Manual

[. . . ] AUTOPILOT NAVpilot-500 FURUNO Authorized Distributor/Dealer 9-52 Ashihara-cho, Nishinomiya 662-8580, JAPAN Telephone : Fax : 0798-65-2111 0798-65-4200 All rights reserved. Printed in Japan FIRST EDITION : APR. OME-72500 ( HIMA ) NAVPILOT-500 *00014698405* *00014698405* *00014698405* *OME72500G10* *OME72500G10* *OME72500G10* SAFETY INSTRUCTIONS WARNING Do not open the equipment unless you are well familiar with electrical circuits. Only qualified personnel ELECTRICAL should work inside the equipment. SHOCK HAZARD WARNING Do not use the ORBIT mode in rough sea. [. . . ] Note also that "DODG" appears on the display. DODGE mode DODG Heading mode M: Magnetic T: True HDG M RUDDER 359. 9 0 10 20 40 Heading from heading sensor 40 20 10 Rudder angle Dodge mode display 1 Note: To move the rudder to 0° point, press the [PORT] and [STBD] keys at the same time. Release the [PORT] or [STBD] key to leave from the DODGE mode. 3-20 3. STEERING MODE 3. 6. 2 Dodging in AUTO or NAV mode 1. Press the [PORT] or [STBD] key down to change the course until the boat finishes to avoid the obstruction. The equipment goes into the DODGE mode and the audible alarm sounds when one of the above keys is operated, to alert you to dodge operation. Note also that "DODG" appears on the display. Note: Press the [PORT] and [STBD] keys together to fix the course setting value. Course set DODGE mode DODG Heading mode M: Magnetic T: True HDG M RUDDER 359 359. 9 0 10 20 40 Heading from heading sensor 40 20 10 Rudder angle Dodge mode display 2 2. Release the key pressed to return to the previous mode (AUTO or NAV). You can operate the autopilot with the status before the DODGE mode. Note: On Auto mode, the [PORT] and [STBD] keys can be used to change the course degree by 5º, 10º or 20º steps depending on the installation setting. It is useful when you need to change the large course degrees angle rapidly. However, the DODGE mode cannot be used when this function is available. For detail, ask your serviceman. 3-21 3. STEERING MODES This page is intentionally left blank. 3-22 4. MENU OPERATION Most settings are carried out in the menus. The items shown in each menu depend on the mode in use. For the STBY mode the complete menu is shown. When the menu is accessed while in either the AUTO or NAV modes, only the menu items that are most frequently used in those modes are shown. The ALARM menu description is shown on Chapter 5. 4. 1 STBY Mode Menu While in the STBY mode, press the [MENU] key to show the STBY mode menu. This menu shows all of the Navpilot-500's menu items. ALARM MENU PARAMETER SETUP SYSTEM SETUP TEST: OFF SYSTEM DATA STBY mode menu 4-1 4. MENU OPERATION 4. 1. 1 Setting parameters The PARAMETER SETUP menu sets various parameters for the control of the NAVpilot-500. In the STBY mode, press the [MENU] key to open the STBY mode menu. [. . . ] 80°C temperature in drive unit was detected. Current of more than 5 A was detected on the bypass/clutch circuit. No current on the bypass/clutch circuit. Command from the FU remote controller exceeded 55°. [. . . ]