User manual FURUNO XANTREX LINK 10

[. . . ] i4. 25 Link 10 Owner's Manual Xantrex Link 10 Battery Monitor Notice of Copyright Xantrex Link 10 Battery Monitor © November 2002 Xantrex International. Xantrex is a registered trademark of Xantrex International. All rights reserved. Disclaimer UNLESS SPECIFICALLY AGREED TO IN WRITING, XANTREX TECHNOLOGY INC. ("XANTREX") (a) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR SUITABILITY OF ANY TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION. [. . . ] When power is restored, the display defaults to the function and the digital display flashes. Pressing either the SEL or SET buttons cancels the flashing display. If the meter is in the sleep mode when power loss occurs, the display will flash for 10 minutes and then go to sleep if no buttons are pressed. Once asleep, the first button press will wake the display in the flashing mode to annunciate the power loss. The second button press will cancel the flashing display. 27 Reset and Lock In addition to reporting primary system values, the Link 10 is capable of many other front panel functions and will also display important historical battery data. The words below the bar graph display indicate which of these functions you are accessing. To use these functions you must read and understand the following section of this manual. RESET DATA LOCK FUNC Resetting the Link 10 RESET Resets amp hours to zero and resets the Link 10 to factory values. To RESET the amp-hour display to zero, SELect the RESET function as previously described. The letters AH will appear in the display. After five seconds the amp-hour display will be reset to zero and the letters ALL will appear. If you continue to hold down the SET for another five seconds all variables and functions are reset to the factory defaults. RESET DATA LOCK FUNC Front Panel Locking LOCK Prevents user access to Set Up and Advanced Functions. To LOCK the Link 10, SELect the LOCK function as previously described. The letters LOC will appear in the display, indicating you are in the LOCK function. Press SET and the letters off appear, indicating the front panel is not locked. Press SET again and the letters on will appear, indicating the front panel is locked. Repeating this procedure toggles the lock off and on. The display will report off or on indicating Lock off or on. on, 28 Historical Data RESET DATA LOCK FUNC Key Battery Data Displayed DATA Key historical battery information is available through this function. Each time the SEL button is pressed while in the DATA mode the next piece of data is displayed. To see DATA, select DATA as previously described. CEF (Displayed as E99): The Charging Efficiency Factor (CEF) is displayed. This number sets the rate at which amp hours are counted back up during charging. This is an amp-hour CEF, not kWh efficiency. [. . . ] When the Sleep Mode is OFF, the numeric display stays on at all times. In the AUTOMATIC sleep mode (displayed as AUt), the numerics are on whenever charging or discharging exceeds 1 amp. When the rate of charge or discharge remains less than 1 amp for 10 minutes, the numeric display is turned off to conserve power. When asleep, pressing either SET or SEL reactivates the numeric display. [. . . ]