User manual FUTABA 7CAP

[. . . ] 7CAP / 7CHP 7 CHANNEL RADIO CONTROL SYSTEM INSTRUCTION MANUAL Technical updates and additional programming examples available at: www. futaba-rc. com\faq\7c-faq. html Entire Contents © Copyright 2003 1M23N13606 TABLE OF CONTENTS INTRODUCTION . . 3 Additional Technical Help, Support and Service . . 3 Application, Export and Modification . . 5 Safety Precautions (do not operate without reading) . [. . . ] optional: change the channel from 4 to 1. (If needed. ) (Elevator travel) (Rudder travel) to 2/1CH. Where next? Close menu. Set up dual/triple rates and exponential (D/R, EXP) : see p. View additional model setups on the internet: www. futaba-rc. com\faq\faq-7c. html. 46 Snap Rolls at the flick of a switch (SNAP-ROLL) (ACRO): This function allows you to execute snap rolls by flipping a switch, providing the same input every time. It also removes the need to change dual rates on the 3 channels prior to performing a snap, as SNAP-ROLL always takes the servos to the same position, regardless of dual rates, inputs held during the snap, etc. Note: Every aircraft snaps differently due to its C. G. , control throws, moments, etc. Some models snap without aileron; others snap on elevator alone. Most models snap most precisely with a combination of all 3 surfaces. Additionally, rate of speed and acceleration when using the snap switch will affect how the model snaps. For information on using gyros with airplanes for cleaner precision maneuvers, such as snaps and spins without over rotation, see p. Adjustability: Travel: Adjust the amount and direction of elevator , aileron and rudder travel. Default is 100% of range of all 3 channels. Directions: (up/right, down/right, up/left, down/left). This snap-roll function is fully adjustable regarding travels and direction on each of the 3 channels. AIL ELE RUD Right positive(up) + + + Right negative(down) + Left positive(up) + Left negative(down) + Note:Always deactivate the TRAINER function prior to activate SNAP-ROLL function. GOAL of EXAMPLE: STEPS: Activate SNAP-ROLL Adjust elevator Open the SNAP-ROLL function. travel to 55%, rudder travel to 120% in the right/up snap. (Ex: elevator to +55%, rudder to +120%. ) Where next?Close menu. INPUTS: for 1 second. (If basic, to SNAP-ROLL. to +120%. again. ) Set up programmable mixes: see p. View additional setups on the internet: www. futaba-rc. com\faq\faq-7c. html. 47 MIXES: the backbone of nearly every function Mixes are special programs within the radio that command one or more channels to act together with input from only one source, such as a stick, switch or knob. Types: · Linear: Most mixes are linear. A 100% linear mix tells the slave servo to do exactly what the master servo is doing, using 100% of the slave channel's range to do so. [. . . ] Activating an idle-up's throttle curve is what activates that idle-up. . 65, 68 Throttle cut or throttle kill: THR-CUT (ACRO / HELI) Offset mix which closes the throttle servo to a set position when the . assigned switch is moved to shut the engine off without having to fiddle with trim settings. . 33 THROTTLE HOLD: (HELI) makes the throttle servo non-responsive to THROTTLE STICK position, and moves the throttle to idle. [. . . ]