User manual FUTABA 9ZHP PART1

[. . . ] Futaba DIGITAL PROPORTIONAL RADIO CONTROL PCM1024ZA PCM1024ZH PULSE CODE MODULATION SYSTEM Thank you for purchasing a Futaba digital proportional radio control set. Please read this manual carefully before using your set. ATTENTION: 1. Application of Product This product is not intended for use in any application other than for the control of models for hobby and recreational purposes. This product is subject to regulations of the Ministry of Radio/Telecommunications and is restricted under Japanese low to such purposes. [. . . ] Once you press the desired key location, the switch will be darkened on the display. If you press the NUL key, switch activation is disabled. Once selected, you must choose the position of the switch which defines the ON or OFF position. This is done by pressing one of the two (or three, if a 3-position switch) left-arrow keys P to R. If you are satisfied with the choice, press the PRE ( N ) key to get back to the previous screen. If you have used the Timer as an example, the switch you have chosen will be displayed at the bottom of the timer definition area (if no switch is chosen, "**" is displayed). Setting Volume Controls Some functions may be controlled by either stick position or knobs/sliders (for example. In these functions, the VOL key will appear at (O). Press the VOL key to get to the setting screen. You may select the desired function to be set with the right and left-arrow keys (A and R). Next, use the F, H, J , or L keys to define which control selects the volume. Now you must use the +/- key to choose the operating direction of the control. Use the PRE key to return to the previous menu. The same procedure may be used if a stick control, rather than a slider or knob, is desired. In this case you will select the stick and direction as given earlier for the "Setting Stick Activation" section above. Setting STICK Activation If you would rather have your on/off function controlled by the motion of one of the transmitter sticks, press the STK (O) button while in the switch setting display. This displays the STICK SET function in the lower part of the figure. Use the J1 to J4 (A to D) buttons to select the desired stick. Now, you will need to define the position at which the switching occurs. To do this, hold the stick in the desired location and press the SET (Q) key. Finally, select the ON/OFF direction by pressing the +/- (P) key (note that the ACT and INH positions swap each time the button is pressed). When you are done setting up the stick switching, return to the original setting screen with the PRE (N) key. System Section, Page 38 Model Setting Section MODEL SETTING SECTION The following controls and menus are used for model settings. These are settings that may be used individually for any and all of the different model setups stored in the PCM 1024Z's memory. Each model setup can have different model settings -- for example, each model may have different servos reversed, its own name, different transmission type (PCM or PPM/FM), etc. [. . . ] Elevator Dual RateSwitch (ON in lower position) 14. Rudder Dual Rate-- Switch and CH9 (ON in lower position) 9. Collective Pitch Mixing Idle-up Lever Tachometer Sensor Elevator Trim Rudder Trim CAMPac Memory Module -Antenna . 7. Elevator-Flap Mixing Switch (ON in upper position) 11. [. . . ]