User manual FUTABA ATTACK_III

[. . . ] Operation is easier if the transmitter is hung from your neck by using the neck strap. · Nicad operation as standard. SERVO FP-S133 HIGH-QUALITY MICROSERVO_ · Futaba hybrid custom 1C provides high starting output torque, narrow dead-band, and excellent trackability. · Thick film gold plated connector pins insure positive contact connector shape increase reliability against shock and vibration. The connector housing has a reverse insertion prevention mechanism. [. . . ] Adjust to the length of your hand. 18 Servo reversing switches Using the servo reversing switches · The left side of each switch is the normal position. · The servo reversing switches reverse the direction of operation of the servos. 5 Lever head Lever head Rudder servo reversing switch Throttle servo reversing switch Elevator servo reversing switch Aileron servo reversing switch NORM-> Normal REV-> Reverse Unlock lever heads and , by turning them in the arrow direction, and adjust the head to the most comfortable length, then lock it by turning it in the direction opposite the arrows. Fig. 3 Charging jack Use this jack for charging. Transmitter crystal Battery cover Charging of transmitter and receiver Nicad batteries Recharge the receiver and transmitter Nicad batteries as shown in Fig. Charger PBC-8B After linkage is complete, inspect the servos. If the direction of operation of the stick lever and the direction of operation of a servo are opposite, switch the appropriate servo reversing switch. Fig. 6 The tension of the stick lever spring can be adjusted. LED When these screws are removed, the back cover can be removed. ·The tension of the spring can be adjusted by removing the transmitter back cover and turning the screw for each stick. Set the springs for the best stick feel. Charging plug for transmitter. Tx Transmitter Nicad battery NT-8JY Rx Fig. 4 Battery cover NR-4QB · Connect the charging plug of the dual charger to the transmitter charging jack. Starting the drive motor suddenly is dangerous. This also applies when the idle point trimmer is changed. · If an overcurrent flows continuously in the motor for some reason, the heat protector will operate and stop the motor. When the temperature drops after a short time, the motor can be controlled once more. Correct the cause of the continuous overcurrent before using the set. · The heat protector does not protect the set against momentary overcurrent caused by shorting of the drive motor lead wires, etc. · If the drive motor is stopped by the "autocut" function during flight, land the aircraft immediately and safely. The idle point trimmer sets the drive motor idling point. · Set the transmitter throttle servo reversing switch to the normal position. · Set the transmit throttle stick to the slowest position (stick all the way back ), turn on the MCR-4A power switch, press the start switch, and set the idle point trimmer to the point at which the motor idles. · If the start switch is not pressed, the drive motor will not run. · Turn the idle point trimmer slowly and without too much force. PRECAUTIONS · Connect the receiver (or MCR-4A), servos, switches, and battery firmly as shown in Fig. [. . . ] Tighten the mounting screws until the rubber grommet is crushed slightly. If the screws are too tight, the cushioning effect will be adversely affected. SERVO MOUNTING · Spare servo horns are supplied. · Wrap the receiver in sponge rubber. [. . . ]