User manual FUTABA FP-7FGH

[. . . ] Futaba DIGITAL PROPORTIONAL RADIO CONTROL Thank you for purchasing a Futaba digital proportional radio control set. Please read this manual carefully before using your set. CONTENTS ·FEATURES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 ~4 · Inside Rear Trimmer Panel . 8 ·CHARGING OF TRANSMITTER AND DECEIVER Ni-Cad BATTERIES . [. . . ] 9 Lever head (A) Lever head B 17 Idle-up trim control Sets the idling speed when the 16 idle-up switch is ON. 18 Throttle hold switch When this switch is set to ON, the throttle servo stops at the position set at the 1 2 trimmer and only the pitch servo operates. This switch is used in auto-rotation dives. Both throttle and pitch servos mixing is performed when this switch if OFF. 19 Rudder dual rate switch Rudder dual rate ON-OFF switch. Similar to aileron dual rate, at dual rate ON, the rudder deflection can be adjusted with the rudder dual rate trimmer Fig. 10 Inside rear trimmer panel 1, 2 Aileron ATV (Adjustable Travel volume) trimmer [2] RIGHT is for the right aileron and 1 LEFT is for the left aileron. The servo travel volume is independently adjustable to the left and right from the neutral position. Travel adjustment ranges 0 to 100%. Neutral Right Left Adjustable with rudder ATV right knob (right full Aileron) Adjustable with the rudder ATV left knob (left full Aileron) Throttle servo Fig. 11 3 Aileron dual-rate trimmer adjusts the aileron travel when the 12 aileron dual-rate or VTR switch ON. 4 DR (dual-rate) <-> VTR (Variable Trace Ratio) switch 5 6 Aileron-rudder MIX trimmer (From aileron to rudder) Adjust the mixing volume and the mixingdirection of rudder. After linkage is completed adjust the MIX direction and amount with trimmers. MIX amount adjustment ranges 0--100% each, the same adjustment can be done even if the servo is reversed. 7 Aileron -> rudder switch mixing ON-OFF 14 Throttle -> Rudder mixing ON-OFF Switch This switch turns mixing from the throttle control (channel 3) to the rudder (channel 4) ON and OFF. The adjustment range is same as the aileron ATV. 16 ·Connect the charging plug of the FBC-2 charger to the transmitter charging jack, connect the 3P connector of the FBC-2 to the receiver NiCad battery NR-4J, and plug the FBC-2 to a 110VAC (220V, 240V) outlet as shown in this figure. The TX and RX charging LED light; indicating that the batteries are being charged. ·The Receiver battery can be used about 10 times at 10 minutes per flight between rechargings. ·Charge the batteries for about 15 hours. When the set is not in use for some time, repeat discharge and charge, two to three times before use. (If the batteries are not used for a long time, their capacity will go down). ·FBC-2 charges transmitter and receiver Ni-Cad batteries independently or simultaneously. TRAINER Connect the transmitters with the trainer cord (M-TC, purchased separately) as shown in Fig. [. . . ] ·Therefore, always attach the correct frequency flag to the end of the transmitter antenna. Each frequency band has its own designated color, as stated above. The frequency flag is intended for identification purposes. ·Also change the frequency flag when frequency is changed. [. . . ]