User manual FUTABA FP-7G

[. . . ] SPECIAL FEATURES Maximum class 7 channels * Transmitter FP-T7G · Dual travel ailerons, dual travel elevator built-in. · Maximum operation sensation through prudent design and adoption of open gimble and stick mechanism. [. . . ] 2 ·Refer to Fig. 2 for the operation of each channel and the name of each part. ·When the power switch is set to ON, the pointer of the level meter will deflect. Since this indicates the antenna output, it should deflect to graduation 7. Since this indication is different when the antenna is contracted and when it is extended fully, check the indication when the antenna is extended fully. (The indication will also be different when the antenna is held in your hand and when free ) ·Next, push the battery check switch. The level meter will indicate the battery voltage at this time. The battery is OK if the meter pointer deflects to the green zone. Charge the battery when the pointer deflects to the boundary between the green and red zones. ·Using dual travel When the dual travel switch is set to ON, the steering angle can be made small within the range of the hatched lines of Fig. 3. The steering angle is variable within the range maximum, 90% of total operating angle, minimum 40%. ·The dual travel aileron switch should normally be set to OFF Set this switch to ON when desiring to make the aileron steering angle small such as slow roll, etc Then set the steering angle with the trimmer *The dual travel elevator switch should normally be set to OFF But when desiring a large steering angle such as spins, etc , set the switch to ON and adjust the steering angle with the horn adjuster trimmer for level flight. [. . . ] 3 Plugs or other modifications which interfere with factory test procedures will be returned to factory standard at your expense 4 Carefully pack all components individually, using sufficient packing material to prevent damage during shipment 5 Include a brief but thorough explanation of all problems and service required and tape it to the back of the transmitter Place a label describing the functions of the servo on each servo 6 Be sure to include your full address and zip code inside the box as well as on the outside 7 Include a packing list of all items being returned, and double check to make sure that all items are packed 8. Upon receipt of damaged equipment at the FUTABA factory, an estimate of the cost of repair will be sent to you Your equipment will then be repaired and returned to you upon receipt of payment. This factory repair service applies only to the continental U S A . [. . . ]