User manual FUTABA FP-8SSAP

[. . . ] Futaba DIGITAL PROPORTIONAL RADIO CONTROL SINGLE STICK PULSE CODE MODULATION SYSTEM PCM Thank you for purchasing a Futaba digital proportional radio control set Please read this manual carefully before using your set. The names and functions of the transmitter controls can be easily understood by reading this section with the three-fold page at the end of this manual unfolded. TABLE OF CONTENTS GENERAL INFORMATION Features . . 4 INDEX FOR TRIMMER PANEL FUNCTIONS Switch or Trimmer Number 1 2 3 4 5 6 7 8 9 10 11 13 14 15 16 17 18 19 20 21 22 23 24 Description Ref. . . 5~6 Glossary of Terms Basic Transmitter Controls . . . . . . . . . . . . . . . . . . 6~9 Batteries and Charging Instructions . . 15 ADJUSTMENTS AND FLIGHT TECHNIQUES Basic Linkages and Installation . [. . . ] 2. FS SELECT This position allows setting of fail safe and hold as described in the "HOW TO USE FS" section. 3. ATV This position allows setting ATV as described in the "HOW TO USE ATV" section. 4. TEST A This position allows servo test A as described in the "SERVO TEST" section. 5. TEST B This position allows servo test B as described in the "SERVO TEST" section. 6. BFS MEMO SET Switch to this position when setting the BFS release point as described in the "BATTERY FS MEMORY SETTING" section. 7. OFF Normally set to this position. 18 [49] Function select switch Fig. 23 ADJUSTMENTSANDFLIGHTTECHNIQUES ·2ND ATV (CONVENTIONAL) 2ND ATV is available on the aileron and elevator channels. This is the conventional type ATV and is set using trimmers [34], [35), [36], and [37] on the transmitter back panel. Servo movement can be adjusted from 0 to 100%. These adjustments are retained even if the transmitter battery reaches a full discharge state (Memory ATV settings are not. ). When the ATV trimmer is turned clockwise, the steering angle increases. When the ATV trimmer is turned counterclockwise, the steering angle decreases. The steering angle can be adjusted from 0 to 100%. [34]Aileron right- [36] Elevator up [35]Aileron leftFig. 24 [37] Elevator down SERVO REVERSING SWITCHES These switches reverse the direction of rotation of the servos. They are convenient when connecting the linkage. 19 [42]CH5 switch channel NORM: Forward REV: Reverse [44] Spoiler [40] Throttle [45]Pitch control [38]Aileron [41]Rudder [39]ElevatorFig. 25 ADJUSTMENTS AND FLIGHT TECHNIQUES ·USING DUAL RATE (AILERON, ELEVATOR, AND RUDDER) Dual rate functions allow the flyer to alter the maximum servo travel (and therefore control sensitivity) during flight by using the appropriate rate switch. At D/R OFF, servo deflection is maximum in both directions (unless limited by ATV setAILERON DUAL RATE · The aileron rate switch 14 has two D/R ON positions. Thus three different servo travel rates are available on aileron. Rates can be adjusted to suit varying aircraft and maneuver requirements. 1 Aileron dual rate trimmer (I) This trimmer sets the aileron travel when the aileron dual rate switch 14 is set to the dual ON I position. 2 Aileron dual rate trimmer 2 This trimmer sets the aileron travel when the aileron dual rate switch 14 is set to the dual ON 2 position. Trimmers [1] and [2] can adjust the aileron travel from 40% to 80% of the total travel. [. . . ] Always use a Futaba crystal set (transmitter, receiver) when changing the frequency. ·It is illegal to change crystals of transmitter on the 72-75MHz bands in the U. S. A. FACTORY REPAIR SERVICE To insure prompt service, please follow the instructions given below. Charge the batteries for at least 18 hours prior to shipment. Remove the servos from their mounts and remove the foam padding from the receiver. [. . . ]