User manual FUTABA R6004FF

[. . . ] For Indoor Use Aircrafts R6004FF Limited flight range: 300ft. [. . . ] Otherwise the receiver may break down or the wire may burn out. away from Keep to avoid the conductive material short circuit. Usage Precautions This model is designed for short range application such as indoor use aircrafts. Please read the usage condition shown below. · Do not exceed 300ft. (100m) for flight range. · Transmitter's antenna must NOT point to the receiver when flying as specified in the transmitter's instruction. · Please be sure that the ESC's regulated output for receiver has enough capacity to sustain the entire operating condition of your servos, battery, and motor. · After the linking is done, please cycle receiver power and check if the receiver to be linked is really under the control by the transmitter to be linked. · Please do not perform the linking procedure with motor's main wire is connected as it may result in serious injury. Easy Link Switch Press and hold, One(1) second to re-set F/S position for 3ch. (with TM7, TM8) Range Check the Radio 1 2 1 Please follow the transmitter's instruction manual and check if the range is over 10 paces. More than two(2) seconds to relink the transmitter's ID. * Place the transmitter within 2 ft. [. . . ] TEL (217)398-8970 or E-mail: support@futaba-rc. com (Support) TEL (217)398-0007 or E-mail: service@futaba-rc. com (Service) Easy Link Button LED Indication Green Off Solid Blink Red Solid Off Off Status No signal reception Receiving signals Receiving signals but ID is unmatched Unrecoverable failure (EEPROM, etc. ) 3/MC: CH3/ESC 1: CH1 FUTABA CORPORATION Phone: (043) 296-5118 Facsimile: (043) 296-5124 Makuhari Techno Garden Bldg. , B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan 1M23N17417 ©FUTABA CORPORATION 2008, 11 (1) Alternate blink [. . . ]