User manual FUTUBA MSA-10

[. . . ] ·A separate battery pack can be used for the servos connected to the MSA-10. ·Easy setting by rotary and push switches. ·Setting state display by LED. MULTI SERVO ADJUSTER MSA-10 INSTRUCTION MANUAL [Example of primary use] The MSA-10 can use one servo input signal to simultaneously drive up to four servos. [. . . ] The power supply voltage (4. 8 or 6V) depends on connecting servos. ·LED ·Servo output connector 1/5, 2/6, 3/7, 4/8 MSA-10 ·Push switch (DEC) [Usage Method] 1 Connect the servo input connector to the receiver servo output channel. 2 Connect the servos (maximum 4) to the servo output connectors (1/5 to 4/8) of the MSA-10. 3 Set the transmitter stick and trim to the neutral position and install the horn to each servo. 4 Adjust the neutral position of each servo using the neutral position adjustment function of the MSA-10. 5 Connect the linkage and adjust the linkage so that unreasonable force is not applied to the servo at the neutral position. 6 Push either one of the transmitter sticks fully in any direction and individually adjust the throw of the servos so that unreasonable force is not applied to the servos. Push the same transmitter stick fully in the opposite direction and individually adjust the throw of the servos so that unreasonable force is not applied to the servos. [When using a separate power supply] Even if using a receiver with Battery Fail Safe function, it can not detect the voltage of the separate power supply. Therefore check the battery voltage and charge the battery quickly. WARNING [Mounting Precautions] Dislodgement of a connector or breaking of a wire due to vibration during flight may cause a crash. Especially, since the number of wires becomes large, be sure to prevent connector dislodgement, broken wires, etc. If using an extension cord, fasten the input connector section with a fastener and take vibration countermeasures. If the extension cord is long, insert an extension cord with filter between the receiver and the MSA-10 to minimize the effects of noise, etc. Connection of a large number of short extension cords will cause a voltage drop. Make the number of extension cord connections as small as possible. Vibrationproof of the MSA-10 by wrapping it in sponge rubber or some such material. [MSA-10 Settings] Notes: ·If the power switch is turned off without returning the rotary switch to 0 or 9 after function setting, the settings will not be memorized. [. . . ] 3 When the LED is on, adjust the throw by pushing the INC or DEC push switch. LED on The LED blinks while the push switch is being pushed. 1 Set the rotary switch to 1, 2, 3, or 4 corresponding to the servo No (given on the MSA-10 nameplate) whose endpoint you want to adjust. 2 When the transmitter stick is pushed to the side whose throw you want to adjust, the LED comes on. 3 When the LED is on, perform throw adjustment by pushing the INC or DEC push switch. [. . . ]