User manual FUTUBA SBC-1

[. . . ] S. BUS System Channel Changer Before using your new SBC-1, please read this manual thoroughly and use the system properly and safely. After reading this manual, store it in a safe place. Channel Setting 1 Connect an S. BUS servo to the S. BUS servo 2 Connect a battery to the battery connection port (BATT. ) LED Blinks slowly (approximately 1 time/second) Lights steadily Status When the CHANNEL SELECT switch No. [. . . ] If a conventional radio control servo is to the S. BUS servo connection this product. Do not disassemble or modifythan those specified by us. will not be responsible for any disassembly or modification other Futaba Corp. will not be responsible for damage caused by combination with other than Futaba Genuine parts. 3 Set the CHANNEL SELECT switch No. to the 4 Hold down the set switch (SW). (Approximately 1 second) channel you want to set at the S. BUS servo. * During channel setting, the LED blinks rapidly (approximately 5 times/second) and then lights steadily. * When the LED lights steadily, channel setting is complete. In this case, check the following: Check items ·Isabatteryconnectedtothebatteryconnection port?·Is an S. BUS servo or S. BUS decoder connected to the S. BUSservoconnectionport?·A re the battery and S. BUS servo connectors firmlyinsertedfully?·A r e t h e b a t t e r y a n d S . B U S s e r v o c a b l e s damaged, broken, etc?·Isthebatterycharged? port, the servo may operate erroneously. 5 Remove the battery. 6 Remove the S. BUS servo. Refer to the instruction manual of each device for a description of the channel setting method of the S. BUS compatible devices (S. BUS decoder, etc. ) other than a servo. Precautions ·Do not connect the power source with the SW presseddown. Ifthepowersourceisconnected when the SW is pressed, the LED will light and Name of Each Part and Accessories Channel select switch Set switch Status display LED (red) Dust cover x2 (Vacant connectors) CAUTION connector dust cover of the vacant connectors. [. . . ] Please contact our service center if you feel that any corrections or clarifications should be made. FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983 1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan = Prohibited = Mandatory 1M23N23101 ©FUTABA CORPORATION 2010, 2 (1) [. . . ]