User manual GAF EVERGUARD H2O BONDING ADHESIVE UPDATED 2009

[. . . ] 15 mg/m3 ­ total ACGIH 2 mg/m3 TWA Respirable OTHER REL: 5 mg/m3 ­ resp. 10 mg/m3 ­ total 4 ppm Vinyl acetate 108-05-4 0. 1 ­ 1 NE 10 ppm NE = Not Established SECTION 3: HAZARDS IDENTIFICATION PRIMARY ROUTE OF EXPOSURE: SIGNS & SYMPTOMS OF EXPOSURE EYES: SKIN: Eye contact may cause eye irritation. Prolonged or repeated skin contact may cause irritation, dermatitis and drying of the skin. [. . . ] Carbon dioxide, carbon monoxide, ammonia. Wear impermeable protective clothing and self-contained breathing apparatus. N/A SECTION 6: ACCIDENTAL RELEASE MEASURES ACCIDENTAL RELEASE MEASURES: Prevent further leakage or spillage if safe to do so. Do not allow material to contaminate ground water system. Do not allow product to enter sewer or waterways. Wear appropriate protective equipment and clothing during clean-up. SECTION 7: HANDLING AND STORAGE HANDLING AND STORAGE: For safe storage, store at or above 0 °C (32 °F). Wear suitable protective clothing, safety glasses and gloves. Avoid contact with eyes, skin and clothing. None OTHER PRECAUTIONS: SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION ENGINEERING CONTROLS / VENTILATION: Work should be done in an adequately ventilated area. Local exhaust ventilation is recommended when general ventilation is not sufficient to control airborne contamination. Page 3 of 7 GAF Materials Corporation RESPIRATORY PROTECTION: MSDS # 2104 Use NIOSH approved respirator if there is potential to exceed exposure limit(s). Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists. Use impermeable gloves and protective clothing as necessary to prevent skin contact. Eye washes and safety showers could also be provided. Wash exposed skin prior to eating, drinking or smoking and at the end of each shift. Wash contaminated clothing prior to reuse. N/A EYE PROTECTION: SKIN PROTECTION: OTHER PROTECTIVE EQUIPMENT: WORK HYGIENIC PRACTICES: EXPOSURE GUIDELINES: SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE & ODOR: FLASH POINT: METHOD USED: EVAPORATION RATE: Cream colored liquid with a acrylic odor. Aqueous Solution No data Slower than diethyl ether 7. 7 ­ 8. 3 Miscible Heavier than air. No data No data LOWER EXPLOSIVE LIMIT: UPPER EXPLOSIVE LIMIT: BOILING POINT: No data No data 100 °C (212°F) pH (undiluted product): SOLUBILITY IN WATER: VAPOR DENSITY: VAPOR PRESSURE: VOC WITH WATER (LBS/GAL): MELTING POINT: SPECIFIC GRAVITY: PERCENT VOLATILE: MOLECULAR WEIGHT: WITHOUT WATER (LBS/GAL): No data 1. 1 (Water = 1) No data No data No data SECTION 10: STABILITY AND REACTIVITY THERMAL STABILITY: CONDITIONS TO AVOID (STABILITY): INCOMPATIBILITY (MATERIAL TO AVOID): STABLE X Freezing conditions. [. . . ] Such information is to the best of our knowledge and belief accurate and reliable as of the date compiled. However, no representation, warranty or guarantee, expressed or implied, is made as to its accuracy, reliability, or completeness. It is the user's responsibility to satisfy himself as to the suitability and completeness of such information for his particular use. [. . . ]