User manual GAF EVERGUARD LOW VOC TPO PRIMER MATERIAL SAFETY DATASHEET UPDATED 09-2009

[. . . ] Can cause gastrointestinal irritation, nausea, vomiting, diarrhea. Prolonged inhalation of vapors may cause irritation of the respiratory tract and central nervous system depression (narcosis) characterized by headache, dizziness, muscular weakness and fatigue. Inhalation of toluene vapors above 200 ppm may result in impairment of coordination, increased reaction time and a bad taste in the mouth. May cause unconsciousness if exposure is excessive. [. . . ] Control the source of the spill if it is safe to do so. Ventilate enclosed areas to prevent vapor accumulation. Restrict access by unauthorized personnel. Absorb spilled product with vermiculite or other absorbent material. Shovel or scoop into a sealable container for disposal. SECTION 7: HANDLING AND STORAGE HANDLING AND STORAGE: Do not store or handle near an ignition source. Effectively ground the product transfer system to prevent fire or explosion from static discharge. Empty containers may contain residual product. Do not reuse containers unless properly reconditioned. None. OTHER PRECAUTIONS: Page 3 of 7 GAF Materials Corporation MSDS # 2123 SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION ENGINEERING CONTROLS / VENTILATION: General exhaust as needed to keep work environment below exposure limits if engineering or administrative controls are not adequate. For large spills or entry into enclosed small spaces with inadequate ventilation, a pressure demand, self-contained breathing apparatus is recommended. If engineering or administrative controls are not adequate to maintain work environment below solvent TLV recommended levels, an appropriate respirator should be used in conjunction with a respirator use and fit training program. Safety glasses with side shields or goggles. To prevent repeated or prolonged skin contact, wear impervious clothing and boots if contact is likely. Avoid prolonged or repeated contact with the skin. Remove contaminated clothing and launder before reuse. Cleanse skin thoroughly after contact, before work breaks and meals, and at the end of the work day. Product is readily removed from the skin with waterless hand cleaners followed by washing thoroughly with soap and water. Eye wash stations should be available where product may come in contact with the eyes. N/A RESPIRATORY PROTECTION: EYE PROTECTION: SKIN PROTECTION: OTHER PROTECTIVE EQUIPMENT: WORK HYGIENIC PRACTICES: EXPOSURE GUIDELINES: SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE & ODOR: FLASH POINT: METHOD USED: EVAPORATION RATE: pH (undiluted product): SOLUBILITY IN WATER: VAPOR DENSITY: VAPOR PRESSURE: VOC WITH WATER (g/L): Translucent liquid with aromatic odor. 45°F No data No data No data Insoluble >1 22 mm Hg @ 68°F 240 grams/liter LOWER EXPLOSIVE LIMIT: UPPER EXPLOSIVE LIMIT: BOILING POINT: MELTING POINT: SPECIFIC GRAVITY: PERCENT VOLATILE: MOLECULAR WEIGHT: WITHOUT WATER (g/L): 1. 2% 7. 0% 111°C No data 1. 15 ­ 1. 25 90% No data No data Page 4 of 7 GAF Materials Corporation MSDS # 2123 SECTION 10: STABILITY AND REACTIVITY THERMAL STABILITY: CONDITIONS TO AVOID (STABILITY): INCOMPATIBILITY (MATERIAL TO AVOID): HAZARDOUS DECOMPOSITION OR BYPRODUCTS: HAZARDOUS POLYMERIZATION: STABLE X UNSTABLE Avoid flames, sparks, or other sources of ignition. [. . . ] The following components appear on one or more of the following state hazardous substances lists: Chemical Name Parachlorobenzotrifluoride Toluene CAS # 98-56-6 108-88-3 CA Yes Yes MA Yes Yes MN Yes Yes NJ Yes Yes PA Yes Yes RI Yes Yes SECTION 16: OTHER INFORMATION ADDITIONAL COMMENTS: DATE OF PREVIOUS MSDS: None New MSDS Page 6 of 7 GAF Materials Corporation CHANGES SINCE PREVIOUS MSDS: N/A MSDS # 2123 This information relates to the specific material designated and may not be valid for such material used on combination with any other materials or in any process. Such information is to the best of our knowledge and belief accurate and reliable as of the date compiled. However, no representation, warranty or guarantee, expressed or implied, is made as to its accuracy, reliability, or completeness. It is the user's responsibility to satisfy himself as to the suitability and completeness of such information for his particular use. [. . . ]