User manual GAF MASTER FLOW POWERED UPDATED 2010

[. . . ] Make sure blade is on tight and ensure the set screw is securely tightened. Use this unit only in the manner intended by GAF. If you have any questions, please contact Master Flow® Technical Services at 1-800-211-9612. Important: your solar panel configuration may 60m) in from the exterior wall of the house (Figure 1a) and at least 2' (. [. . . ] Be sure that the arrow marked in the flashing points up to the roof peak. Secure the unit into place with galvanized roofing nails at all four corners and approximately every 4" (10. 2cm) along the sides of the flashing (Figure 4). Finish by using roof cement to seal all flashing and shingle edges, as well as nail heads and stack vertical seam. press all raised shingle edges back into position. Warning: Using excess roof cement may cause blistering in the roofing shingles. Note: The optimum angle can be calculated by using the approximate latitude of the house plus 20 degrees. Notice: If parts and/or accessories are missing, or this product does not operate correctly, contact Master Flow® Technical Services. ® GAF Materials Corporation (GAFMC) warrants to you, the original owner of the Master Flow® powered ventilation products listed below, that GAFMC will reimburse you in accordance with this warranty if your Master Flow® powered ventilation products do not perform properly as a result of a manufacturing defect. Or application not in strict accordance with GAFMC's printed application instructions. B) Settlement, movement or defects in the building, walls, foundation, roof deck, or materials adjacent to or over which Master Flow® powered ventilation products were installed. Damage to your Master Flow® powered ventilation products or leaking into your building resulting from factors beyond GAFMC's control, including, but not limited to: a) Acts of nature, such as hail, storms, or winds. Chipping, fading or peeling paint on your Master Flow® powered ventilation products. Labor costs for removing or replacing your Master Flow® powered ventilation products except as specifically provided for above or for any other roofing or building materials. materials Corporation and represents the SOle reMeDy available to any owner of GAFMC's powered Master Flow® ventilation products. GAFMC makes nO OTHer repreSenTATIOnS, COnDITIOn, GUArAnTy Or WArrAnTy of any kind other than that stated herein. GAFMC WIll nOT Be lIABle In Any evenT FOr COnSeQUenTIAl, punitive, special, InCIDenTAl or similar DAMAGeS OF ANY KIND, including DAMAGE TO THE INTERIOR Or exTerIOr OF Any BUIlDInG, whether for breach of this warranty, negligence, strict liability in tort, or for any other cause. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages so the above exclusions or limitations may not apply to you. The warranty period listed above starts at the completion of installation of your Master Flow® powered ventilation products and terminates if either your Master Flow® powered ventilation products are replaced or if the building is sold or transferred (subject to the limited transferability provision below). For any Master Flow powered ventilation product that does not perform properly as a result of a manufacturing defect, GAFMC will provide you with replacement product. [. . . ] However, GAFMC will nOT compensate you for: 1. Damage to your roof or your building or resulting from anything other than an inherent manufacturing defect in your Master Flow® powered ventilation products, such as: a) Improper installation of your Master Flow® powered ventilation products, faulty application To file a claim under this Warranty, you must send a notice of claim in writing describing your complaint, together with proof of purchase to establish that you are the original or second owner and proof of application date, and photographs of the affected products (if possible) to: LL Building Products Inc. , a subsidiary of GAFMC , 295 McKoy Rd. , Burgaw, NC 28425, within 30 days after your discovery of a potential manufacturing defect. [. . . ]