User manual GAGGENAU AH600990

[. . . ] Operating and Assembly Instructions AH 600-990 Coanda Extractor Hood 0 0 1 2 3 AH 600-990 Preface 1. Important notes 1. 1 For your safety 1. 2 Operating for the first time 1. 3 About use 2. Structure and operating principle 2. 1 Structure of the appliance 2. 2 Accessories/special accessories 2. 3 Operating principle 3. Operation 3. 1 Switching on and off 3. 2 Special functions 4. [. . . ] ­ The extractor hood continues running for 10 minutes. Switching off: ­ Turn the "Ventilation level" control knob to the 0 position. or ­ Press the (After-running) key. 0 0 1 2 3 Fig. Cleaning and care Cleaning the grease filters: The (Grease filter saturation) symbol flashes on the display after an operating time of 30 hours. Flashing of this symbol signals to you that the grease filters have to be cleaned. The grease filters can be cleaned at any time, even if the (Grease filter saturation) symbol does not flash. The metal filters can be removed easily for cleaning. Proceed as follows: ­ Grip the grease filter handles and press the slide towards the rear. ­ Pull the grease filter out of its mount in the downward direction (Fig. ­ Repeat the operation with the other grease filters. You can clean the metal grease filters in a dishwasher at a maximum temperature of 65 °C. Place the grease filters vertically in the dishwasher to ensure that no food remainders will stay on them. Slight discoloration can occur when cleaning the grease filters in a dishwasher. Fig. 13 When replacing the grease filters, wipe out the inner part of the housing with hot detergent solution. Reinsert the grease filters in the hood after cleaning. Install them in the reverse order to removal. Note: The handles of the grease filters must be visible after installation. They can no longer be removed if the handles are in the inner part of the housing. Press the (Grease filter) key to set the elapsed hours counter to zero; the (Grease filter) symbol stops flashing. ­ Remove the screws on the lamp cover. The lamp cover tilts down and cannot be removed from the appliance (Fig. ­ Turn the lamp to the left and remove the lamp (Fig. 15 Defective lamps must only be replaced by lamps of the same type (Cool Beam)!You can obtain the original spare part (No. [. . . ] In certain circumstances you may have to countersink the drill holes. Fit the included dowels a in the other drill holes. Note: Pay attention to any special accessories that you may have to fit. ­ Unscrew the two black plates on the left and right of the chimney. [. . . ]