User manual GAGGENAU CK270604

[. . . ] Operating and Assembly Instructions CK 270-604 Glass-ceramic hob with Superquick cooking zones 0 1 9 1 0 9 1 0 9 1 0 9 3 7 3 7 3 7 3 7 CK 270-604 Preface Important safeguards 1. Important notes 1. 1 For your safety 1. 2 Operating for the first time 1. 3 About use 2. Structure and operating principle 2. 1 Structure 2. 2 Operating principle 2. 3 Energy saving tips 3. Maintenance 5. 1 Overview 5. 2 Remedying slight malfunctions yourself 6. [. . . ] This will eliminate any 'newness' smells and soiling (see chapter entitled "Cleaning and care"). ­ Tip: If you have a glass insurance, we recommend that you have your new glassceramic cooking range included. ­ Operation of the appliance must be discontinued immediately if improper use produces cracks, breaks or flaws on the cooking surface, with the result that live parts can come into contact directly or indirectly with seeping liquid or if there is a risk of injury. Remove the mains plug or actuate the corresponding mains fuse. ­ Before operating the appliance for the first time, make sure that the mains connection is in proper working order. 5 1. 3 About use The appliance is intended solely for use in the household and must not be put to any other uses. Use the appliance to prepare meals only. It must not be used to heat up the room in which it is installed. Do not use the cooking surface as space to store items. Place a cooking vessel on the corresponding hotplate before operating it. Do not remove the cooking vessel until you have switched off the hotplate. The size of pots and pans should correspond to the size of the hotplate. Overheated oils and fats can easily cause fires (e. g. In the event of malfunctions, first check your household fuses. If a problem has nothing to do with the power supply, please contact your specialist dealer or your responsible Gaggenau after-sales service. Built-in temperature protection prevents overheating of the appliance and of build-in furniture. Use of aluminium kitchenware or stainless steel kitchenware with aluminium bases may produce mother of pearl-coloured stains on your cooker. These will not have a detrimental effect on functioning of the cooking surface, though. The glass-ceramic cooker additionally features an individual residual heat display. The residual heat display indicates that, after switching off, a cooking zone has still not cooled down to such an extent that it can be safely touched. It lights up in the residual heat display panel as a red dot for each cooking zone. Use the residual heat to warm up meals, for example. Structure and operating principle 2. 1 Structure 1 SuperQuick cooking zone Ø 145 mm / 511/16" (1200 W) 2 SuperQuick cooking zone Ø 145 mm / 511/16" (1100 W) ; can be switched to 145 x 240 mm / 511/16" x 91/2" (2000 W) 3 SuperQuick cooking zone Ø 180 mm / 71/16" (1800 W) 4 Control knob for front right cooking zone 5 Control knob for rear right cooking zone 6 Display panel for residual heat 7 Control knob for rear left cooking zone 8 Control knob for front left cooking zone 9 Operating indicator 10 SuperQuick cooking zone Ø 145 mm / 511/16" (1000 W), can be switched to Ø 210 mm / 8" (2200 W) The glass-ceramic range features SuperQuick cooking zones. These cooking zones possess good heat distribution properties and light up red while heating up. [. . . ] ­ If all poles of the appliances cannot be isolated from the mains by removing an accessible plug (of a permanent connecting lead), an isolating device with a contact gap of at least 3 mm must be installed (e. g. ­ No warranty claims can be lodged for any damage resulting from failure to observe these instructions. CK 270-604 FD xxxx AC 208/220-240 V 60 Hz 5900/7200 W 31 A 11 The minimum spaces that must be maintained between the appliance cooking surface and the horizontal surface above the cooking top shall be: 2 A 4 1 3 5 A = 30 inches (762 mm) minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet; or A = 24 inches (600 mm) minimum when bottom of wood or metal cabinet is protected by no less than 1/4-inch-thick flame-retardant millboard covered with no less than No. 28 MSG sheet steel, 0. 015-inch-thick stainless steel, 0. 024-inch-thick aluminimum, or 0. 020-inch-thick copper. If an electrically heated warming tray is provided on the back guard of a counter level range, the dimension shall be A = 30 inches (762 mm). [. . . ]