User manual GAGGENAU DF 241-161

[. . . ] Gaggenau Operating instructions Dishwasher DF 240-161 DF 241-161 W3126_A (AU) (Ref. 9000 388 730 (8807) en) en Index 4 4 4 4 4 4 4 4 5 5 5 5 5 6 6 6 6 7 7 7 7 7 7 7 8 8 8 8 8 8 9 9 11 11 11 12 12 12 12 12 12 Washing the dishes . Optical display while the programme is running Remaining running time display . 12 12 12 12 13 13 13 13 13 13 14 14 14 14 15 15 15 15 16 16 16 16 16 17 17 18 18 18 19 19 19 19 19 19 20 20 20 20 20 Safety instructions . [. . . ] Remove the utensils when they have cooled down. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 3 . The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Timer programming You can delay the start of the programme in 1-hour steps up to 24 hours. Press 8 + button until the timer programming display 7 jumps to . Press 8 + or ­ button until the displayed time corresponds with your requirements. Press START button 10 , timer programming is activated. To delete timer programming, press the 8 + or ­ is indicated on the digital display 7 . button until You can change your programme selection at any time until the programme starts. Close the door. Interrupting the programme Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch 1 again. Close the door. 13 Terminating the programme (Reset) Open the door. is indicated on the digital display 3 (buzzer sounds). Close the door. Interior light * 20 Changing the programme When the START button 10 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) Open the door. Hold down programme button A and press START button 10 until on the digital display is indicated. The LED for button A flashes and the digital display displays the factory setting . Press programme button A until the factory set is indicated on the digital display 3 . value To change the setting, Press the button C to switch intensive drying on or off . Close the door. The interior light comes on when the door is opened irrespective of whether the ON/OFF switch 1 is switched on or off. [. . . ] Select programme with the highest temperature. The expected programme duration is indicated on the numerical display 3 . Press the START button 10 until on the digital display is indicated . The numerical display indicates Switch off appliance 1 and turn off the tap. [. . . ]