User manual GAGGENAU DF 460

[. . . ] Operating instructions Dishwasher DF 460 DF 461 9000 163 275 (8603) en en Index 4 5 5 6 6 7 9 10 12 Washing dishes . 13 14 15 16 18 18 19 20 Safety instructions . . Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier. [. . . ] The set value is stored in the appliance. Switching the dishwasher ON Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 7 is pressed The numerical display 4 shows the expected duration of the programme. The programme starts automatically. Switching the dishwasher OFF Several minutes after the programme has ended: Open the door when the programme has ended. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. Optical indicator during operation * * With some models During the rinse programme a light point appears on the floor below the device's door. Only open the dishwasher door when the light point has disappeared. In the case of built-in dishwashers with flush front the light point will not be visible. 13 Interrupting the programme Open the door. There is a risk of water squirting out from inside the appliance. Do not open the door fully until the spray arm has stopped rotating. The programme is retained in the dish- washer memory. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may fly open due to expansion. In order to continue with the stored programme, set the main switch to ON again and close the door. Additional functions * not included with all models Soaking * The soaking cycle runs before the main programme and must be selected before the programme starts. In this additional programme cooking utensils, e. g. pans, bowls, etc. , can be soaked and prerinsed in the bottom basket. 5 g of detergent on the door. Turbo * The programme running time is reduced significantly in the Turbo programme. The energy consumption is increased by up to 30% due to more intensive heating. The time reduction affects the following programmes: Intensive: Time reduction up to 25 % Auto: Time reduction up to 25 % Eco: Time reduction up to 58 % Terminating the programme (Reset) Simultaneously press programme buttons A and C for approx. Switch off the main switch 1 . Top basket washing only * If there are only a few utensils (e. g. glasses, cups, plates), use the top basket. Use slightly less detergent than is recommended for a complete load. Changing the programme When the appliance is switched on, the programme can be changed within minutes. [. . . ] All plastic parts of the appliance are identified by internationally standardised symbols (e. g. When the appliance is being disposed of, the plastic waste can be sorted for environmentally-friendly recycling. Please ask your dealer or inquire at your local authority about current means of disposal. Disposal of redundant appliances Make redundant appliances unusable to prevent subsequent accidents. Dispose of the appliance in an environmentally friendly manner. Warning Children could become locked in the appliance (risk of suffocation) or find themselves in other dangerous situations. [. . . ]