User manual GAGGENAU DF290160

[. . . ] Operating instructions Dishwasher DF 290 DF 291 DI 290 DI 291 9000 126 064 (8601) en en Index 4 5 6 7 8 8 9 10 12 13 serve@Home * . 14 15 16 17 20 21 23 23 24 25 Safety instructions . Before using your appliance for the first time . . Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. [. . . ] Change this setting only if there are streaks (reduce the value) or water stains (increase the value) remaining on the dishes. You can choose a value between 0 and 6. Timer programming You can delay the programme start by 24 hours in steps of 30 minutes. If the option "Time Pre-select" is chosen the display shows "Delay start: 00 mins". Return to the Main Menu by pressing M/OK 2 and start the required programme by pressing the Start Button 4 . This starts the time counting backwards. When the set time has elapsed the programme will start automatically. Until the programme starts you are able to change the set time and programme. To do this, use the button ­ 3 to return to the Main Menu and change the settings. In order to delete the pre-selected time, set the time back to "Delay start: 00 mins". 17 Water Hardness Before starting the appliance for the first time or in case of changes in the water hardness, the dishwasher's softening system must be set to the hardness of your mains water supply. Follow the instructions set out in the chapter "Set-up of the Softening System". Standard Programmes In addition to the rinse programmes available in the Main Menu you can choose among the following standard programmes from the programme "Normal": Extra, Eco 50, Eco 45, Normal 45. Set the desired programme and start the selected programme by pressing the Start Button 4 . If you do not want to use any of the displayed standard programmes return to the Main Menu by using the button M/OK 2 . If you want to cancel the selection of a standard programme in the Main Menu press the button ­ "Back". The selected standard programme will be displayed. By pressing the buttons ­ or + the Main Menu will display the programme "Auto Wash". Language You can change the language selected when the appliance was started for the first time (see chapter "Before Starting The Device For The First Time"). If the option "Language" is chosen the display shows several language abbreviations. The abbreviation of the currently selected language is flashing. In order to choose a different language, press ­ or + 3 until the desired language appears. Confirm the language selection by pressing M/OK 2. All following optical character messages will be displayed in the selected language. Extra Eco 50 Eco 45 Normal 45 Type of Dishes Amount of food remnants State of food remnant Mixed Dishes Little to Many Lightly Adhesive You can find the corresponding programme data (length of time, energy and water consumption) in the short manual. We recommend on principle to use the Auto Programmes because they keep the water and energy consumption as low as possible due to the variable programme run. In the case of the standard programmes on the other hand, the programme run is predetermined. Aqua sensor * * on applicable models The Aqua sensor is an optical measuring device which measures the turbidity of the rinsing water. [. . . ] You received your new appliance in a protective shipping carton. All packaging materials are environmentally friendly and recyclable. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. All plastic parts of the appliance are identified by internationally standardised symbols (e. g. [. . . ]