User manual GAGGENAU DI260130

[. . . ] Gaggenau Operating instructions Dishwasher DI 260 9000 423 799 (8901) en en Index 4 4 4 4 4 4 4 4 5 5 5 5 6 6 6 6 6 7 7 7 8 8 8 8 8 8 8 8 9 9 9 9 10 10 10 10 12 12 12 13 13 13 13 13 13 Washing the dishes . 13 13 13 13 13 14 14 14 14 14 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 19 19 19 20 20 20 20 20 20 20 20 21 21 21 Safety instructions . Switching off salt refill indicator/ water softening system . Switching off rinse-aid refill indicator . [. . . ] value To change the setting, press programme button C . Each time the button is pressed, the set value increases by one level; when the value of has (off). been reached, the display jumps back to Press START button 10 , the set value is saved. Close the door. Timer programming You can delay the start of the programme in 1-hour steps up to 24 hours. Press 8 + button until the timer programming display 7 jumps to . Press 8 + or ­ button until the displayed time corresponds with your requirements. Press START button 10 , timer programming is activated. To delete timer programming, press the 8 + or ­ button until is indicated on the digital display 7 . You can change your programme selection at any time until the programme starts. Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Turn off the tap (not applicable if Aqua-Stop fitted). Remove the utensils when they have cooled down. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch 1 again. Close the door. 14 Terminating the programme (Reset) Open the door. is indicated on the digital display 3 (buzzer sounds). Close the door. Interior light * 20 Changing the programme When the START button 10 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) Open the door. Hold down programme button A and press START is button 10 until on the digital display indicated. [. . . ] Water pressure: at least 0. 05 MPa (0. 5 bar), maximum 1 MPa (10 bar). At a higher water pressure: connect pressure-reducing valve ahead. Inlet rate: minimum 10 litres/minute Water temperature: cold water preferred; hot water max. 60 °C. Protection against frost If the appliance is in a room where there is a risk of frost (e. g. [. . . ]