User manual GAGGENAU KG260224CA

[. . . ] Operating and assembly instructions KG 260 CA Gas cooker KG 260 CA FOR YOUR SAFETY Page 2 Warnings Page 3 Preface Page 4 1. Important notes Page 5-6 1. 1 For your safety Page 5 1. 2 Operating for the first time Page 5 1. 3 About use Page 6 2. Structure and operating principle Page 7-8 2. 1 Structure Page 7 2. 2 Special accessories Page 7 2. 3 Operating principle Page 8 3. Maintenance Page 11 5. 1 General Page 11 5. 2 Remedying slight malfunctions yourself Page 11 6. [. . . ] Preferably use the larger cooking zone for brief cooking, deep fat frying and brief frying of large quantities. Preferably use the smaller ring for soaking, warming up and keeping warm, even when large quantities are involved. 2. Structure and operating principle 2. 1 Structure 1 Pot grille 1 2 High burner, 9500 BTU (2. 8 kW) 2 3 2 3 3 Normal burner, 6500 BTU (1. 9 kW) 4 Control knob for the front left cooking position 5 Control knob for the rear left cooking position 6 Control knob for the rear right cooking position 7 Control knob for the front right cooking position Fig. 2 4 5 6 7 8 Burner head cover 8 9 Burner head 10 Spark plug for automatic ignition 11 Thermal sensor to safeguard the flame 9 10 Fig. 3 11 2. 2 Special accessories You can order the following special accessories: ­ VV 200-000: Connecting strip ­ VD 201-010: Appliance cover (If an appliance cover is fitted, the pot support must be removed when closing. ) 7 2. 3 Operating principle The appliance features one-hand operation. That is to say, the ignition is activated when the control knob is pressed briefly. After igniting, keep the control knob pressed for around 5-8 seconds more because the heat sensor that opens the gas channel has to warm up first. The gas hob has 2 normal burners and 2 highintensity burners. with warm soap solution and a dishwashing brush. ­ Whenever required, clean the burner head with a moist cloth. ­ Soak burnt-in remainders in a little water and detergent. This loosens even the most stubborn of soiling. Do not use any abrasive agents and abrasive sponges. ­ As the result of heat development, slight discoloration can appear on the stainless steel surface. Do not attempt to scrape away such discoloration. Distribute stainless steel care agents uniformly and thinly on the hob (not on the control panel!). This will ensure an even surface and will keep your hob in a good condition for a long period of time. Important: Allow the burner covers to cool down before cleaning them!When assembling, place the burner cover (1) on the burner head (2) so that the four tabs on the bottom edge of the burner cover engage in the corresponding tabs on the burner head (see Fig. Place the pot grids back in position. 1 2 Fig. 7 Wipe off spilt food immediately, thus ensuring that it cannot burn in on the hob. The burner gets very hot during operation! [. . . ] It is unscrewed with a special screw key. ­ Unscrew the nozzle and insert the new nozzle as specified in the main nozzle table. The nozzle must be screwed in fully and firmly (torque 1. 5 Nm) (metallic seal). ­ Please do not forget to stick the new adhesive label included with the nozzle set over the old adhesive label on the gas connection, thus documenting the changeover to a different gas type. [. . . ]