User manual GAGGENAU RF 463-201

[. . . ] Gaggenau en Operating instructions RF463-201 W2981 Issue A (AU) Ref 9000 235 394 en (8703) Please read this manual before installing and using this appliance. Please leave this manual with the owner or in the property. NOTE: This instruction book has been abridged to a single language i. e. English only and updated to AU requirements. 9000 235 394 (8703)) Congratulations In buying your new freezer, you have chosen a modern and qualitatively, high grade appliance. [. . . ] For switching the agitation function on and off. Lock button for the ice and water maker control panel (childproof lock). For switching the permanent light function on and off. The buttons on the control panel are illuminated. Dispensing water D Place a suitable receptacle under the discharge opening. D Press the request water button. Dispensing ends, when the button is released. Tip: The water from the water dispenser is cooled to a pala table temperature. If you would like the water colder, place ice cubes in the glass before dispensing the water. 50 Dispensing ice ! Detachable rest Caution! Do not use the ice dispenser for longer than 3 minutes within a time period of 15 minutes. Wait for a few minutes more before ordering more. Risk of damage to the appliance! D Place a suitable receptacle under the discharge opening. Detach the rest in order to place larger receptacles below the discharge opening. D Press the request ice cubes button. Dispensing ends, when the button is released. or Remove and clean the water capture bowl. Overflow water collects in the water capture bowl and has to be regularly removed. D Press the request button for crushed ice. Dispensing ends, when the button is released. Note: Release the ice dispensing button, when the receptacle is filled approx half way. Ice in the discharge may cause the receptacle to overflow or block the discharge. D D Detach the rest. Remove the sieve and pull out the water capture bowl. Empty the water capture bowl and replace it. Insert the sieve tip the rest back up again. D D 51 Removing and cleaning the ice cube container If ice cubes have not been dispensed for a prolonged period, they will shrink, have a stale taste and stick together. Locking the ice and water dispenser In order to secure the ice and water dispenser against unintentional use activate the childproof lock. D Keep the lock button on the ice and water dispenser control panel pressed for 3 seconds. It is not possible to actuate buttons on the ice and water dispenser. For resetting operation of the buttons: D Keep the lock button on the ice and water dispenser control panel pressed for 3 seconds. D Lift the front ice cube container and pull it out. A full ice cube container is heavy! D Pull out the container, empty and clean with lukewarm water. Thoroughly rub the container and endless screw transportation mechanism (Agitation Function) dry so that new ice cubes cannot freeze to them. Push the ice cube container all the way back onto the supports until it locks into position. D D D If the container cannot be pushed all the way back, twist the screw conveyor in the container. Ice cube production continues. 52 How to save energy D Thawing the appliance The appliance starts to defrost automatically. Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near a heat source (radiator, cooker, etc. ). Allow warm food and drinks to cool down before placing in the appliance!Thaw frozen food by placing it in the refrigerator. The low temperature of the frozen food will then cool the food in the refrigerator compartment. [. . . ] Temperature in the freezer space is too high. The water connection hose is not properly sealed. Low water pressure. Shut off tap incorrectly opened. Water supply has kinks. The water filter is bunged up or used. The discharged water is not g cold. The appliance is newly set up. [. . . ]