User manual GAGGENAU RX496210

[. . . ] Gaggenau en Installation instructions RX 496 Table of Contents Safety and warning notes . Transporting previously installed appliances . Clearance from the appliance to the handle of the adjacent kitchen unit . Clearance from the appliance to the wall . [. . . ] The appliance is very heavy and may tip over while being unpacked. To prevent the appliance from tipping over, do not open the appliance doors until the anti tip stabiliser has been fitted. Proceed with great care, otherwise persons could be injured or the appliance could be damaged. To protect the floor surface from damage during installation: D To ensure safe and troublefree installation and an optimum overall appearance of the kitchen front, the following points must be checked beforehand: !D D D D Floor surface of the installation niche Dimensions of the installation niche Squareness of the installation niche Clearance from the installation niche to adjacent kitchen units and wall Location of the socket Location of the fresh water and outlet connections Stability and security of adjacent cabinet parts All cabinet parts onto which the appliance is screwed must be firmly connected to the wall. D D D Lay a strip of linoleum or similar on the floor to the front of the planned area of installation and fix down with adhesive tape. Transport accessories must be positioned against the centre of the back or sides of the appliance. Never slide the transport accessory underneath the appliance from the front. Risk of appliance damage. D Move the appliance using a dolly or lift truck. Removing the transport packaging 1. Remove the bands from around the carton. Cut the carton open along the printed cutting line and remove it. Use the knife carefully to avoid damaging the surfaces of the appliance. Check the appliance for damage. 13 Removing the transport locks 1. Pull the base panel out towards you. 9. Remove the bands from the wooden blocks and pull the wooden blocks out. 2. Place the base panel in a safe location to protect it from damage. Remove the transport locks from the inside. Unscrew the screws from the four transport locks. Removing the wooden palette The castors on the appliance feet are guided along guide rails on the wooden palette. Lift the appliance at one of its side walls. There must be a second person supporting the appliance on the other side. 8. Loosen the lock nuts on the adjustment spindles of the appliance feet. 2. Pull the raised side as far away from the wooden palette as possible without pulling the castored feet of the appliance off the wooden palette. Do not pull the appliance completely off the wooden palette. [. . . ] Drill pilot holes (drill diameter 2 mm). Secure the angle brackets to the side walls. Position the side walls against the appliance. Secure the angle brackets to the appliance. [. . . ]