User manual GAGGENAU VC230113

[. . . ] Operating and Assembly Instructions VC 230 Glass ceramic cooking range 0 1 9 1 0 9 3 7 3 7 VC 230 Preface 1. Important notes 1. 1 For your safety 1. 2 Operating for the first time 1. 3 About use 2. Structure and operating principle 2. 1 Structure 2. 2 Special accessories 2. 3 Operating principle 2. 4 Energy saving tips 3. Operation 3. 1 Switching on / off 3. 2 Operating with the combination function 3. 3 Settings Table 4. [. . . ] The appliance is not suitable for preparing foodstuffs in aluminium foil or in plastic vessels. ­ Use the residual heat to warm up meals, for example. ­ Remove any spilt food before opening the cover of the appliance. ­ The appliance cover must not be closed after use until the appliance has cooled down. 4 2. Structure and operating principle 2. 1 Structure 1 Pilot light 2 Control knob for front cooking zone 6 3 Control knob for rear cooking zone 4 Residual heat display 5 SuperQuick cooking zone Ø 140 mm (1200W) 5 4 0 0 9 1 9 6 SuperQuick cooking zone Ø 120/180 mm (700/1800 W) 1 Fig. 2 1 3 7 3 7 2 3 2. 2 Special accessories 2. 3 Operating principle You can order the following special accessories ­ VV 200-000: connecting trim ­ VD 201-010: appliance cover The glass-ceramic cooker features SuperQuick cooking zones. These cooking zones possess good heat distribution properties and light up red while they are heating up. The cooking zones are controlled electrically and are switched on and off during operation. Fig. 3 2. 4 Energy saving tips ­ Always cook with the lid on. This considerably shortens the time needed for cooking. ­ Pay attention to the right size when choosing pots and pans. The diameters of pots and pans should correspond to that of the hotplate. ­ Kitchenware should consist of suitable material. Remember that high-quality ktchenware will help to minimise energy consumption. ­ Depending on the experience you have gathered, you can switch off the cooking surface at an earlier time. You can make use of residual heat in this way. Operation 3. 1 Switching on /off Switching on Switching on: Front cooking zone Turn control knob 2 to the left or right to the required cooking level (1-9). 4) 0 1 9 1 0 9 Rear cooking zone Turn control knob 3 to the left to the required cooking level (1-9). 4) 7 3 7 3 The power is set continuously variably. Note: the pilot light 1 lights up as soon as a cooking level has been set. A few seconds after switching on, the individual residual heat display (red dot) indicating the chosen cooking zone lights up in the residual heat display panel. Switching off: Turn the control knob to the 0 position (Fig. [. . . ] Pay attention to the information on the rating plate and connect the PE conductor. Connect the connecting cable to the mains. Connection type Y: if damaged, the mains cable must be replaced by a special mains connecting cable. The mains connecting cable must only be connected by the manufacturer or the manufacturer's after-sales service. 11 6. 3 Installation and removal 8, 5 288 510 1, 7 m 33 min. [. . . ]