User manual GAGGENAU VE260934

[. . . ] The appliance corresponds to protection class I and may only be operated with a protective earth connection. Check the mains cable regularly for signs of damage. Do not use the appliance if the mains cable is damaged. [. . . ] Observe the minimum distance to side walls or furniture parts and to the rear wall. This appliance is not intended for operation with an external timer or an external remote control. Removing the appliance Disconnect the appliance from the power supply. Do not lever out the appliance from above. Preparing the furniture The surrounding kitchen unit must be heat-resistant to at least 90 °C. The stability of the unit must be maintained after producing the cut-out. Produce the cut-out for one or several Vario appliances. Proceed as shown in the installation sketch. The angle between the cut surface and the worktop must be 90°. After producing the cut-out, remove the shavings. Seal the cut surfaces to make them heat-resistant. Observe a minimum clearance between the appliance housing and parts of the unit of 10 mm. Protection against accidental contact from below must be guaranteed after installation. If the underside of the appliance can be touched after installation, an intermediate shelf must be fitted that can only be removed using a tool. Observe a minimum clearance between the appliance and the shelf of 10 mm. When fitting several Vario appliances: allow for the additional space required for the connecting strip VV 200. Appliances can also be fitted in individual recesses, if a minimum clearance of 40 mm between the appliances is observed. Electrical connection Check the electrical installation system before connecting the appliance. Make sure that the household installation has sufficient fuse or circuit breaker protection. Check that the appliance has the same voltage and frequency as the electrical installation system (see rating plate). The appliance corresponds to protection class I and may only be operated with a protective earth connection. [. . . ] The centre marking on the mounting rails must be precisely flush with the centre marking of the recess. Note: when fitting the appliance in a stone worktop glue on the mounting rails with a temperature-resistant two-component adhesive (metal on stone). The snap-in pins on the appliance must lie exactly on the catch springs. [. . . ]