User manual GAGGENAU VG421210CA annexe 2

[. . . ] Operation, Maintenance and Installation Manual VG 421 AU Built-in gas hob VG 421 AU FOR YOUR SAFETY Warnings 1. Important Notes For Your Safety Operating for the First Time About Use 2. Features Features of the Appliance Control Knobs Burner Parts 3. Installation Instructions Important Notes on Installation Connecting the Appliance Preparing the Cabinet Installing the Hob Installing the Spindles Nozzle Replacement Fitting the Appliance Cover Page 2 Page 3 Page 5-6 Page 5 Page 5 Page 6 Page 7 Page 7 Page 7 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12-13 Page 14 Page 15 Page 16-17 Page 18-26 Page 18 Page 19 Page 20 Page 21 Page 22-23 Page 24-25 Page 26 1 FOR YOUR SAFETY WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. [. . . ] This loosens even the most stubborn of soiling. Do not use any abrasive agents and abrasive sponges. · Only use very little water to clean your cooktop. Be careful that no water enters the burner base. · As the result of heat development, slight discoloration can appear on the stainless steel surface. Do not attempt to scrape away such discoloration. Distribute stainless steel care agents uniformly and thinly on the hob. This will ensure an even surface and will keep your hob in a good condition for a long period of time. · Make sure the burner parts are dry before assembly. Only operate the appliance with all parts dry. Damp burner parts will cause malfunctions when igniting or unstable flames. · When assembling the burner parts, make sure that the burner ring and burner head are placed in such a way that the locking lugs fit in the corresponding recesses. burner head electrode burner base Note: to avoid jeopardising the electrical safety of the appliance, do not use high-pressure or steam jet cleaning devices ­ risk of short circuits!Before cleaning, please wait until the cooktop has cooled to hand-warm. Never switch on the cooktop while cleaning. Keep the ventilation openings on the rear of the appliance clean. 12 Part / Material Pot Grid (enamel on cast iron) Burner Head Cover, Burner Ring, Burner Head (brass) Electrode Suggested Cleaning Procedure Take pot grids off for cleaning. Remove coarse soiling with damp cloth and detergent. Use brass polish to keep the original shiny surface. Clean with brush, fine glass-paper or scouring pad. Important Reminders Do not clean in a dishwasher. Abrasive cleaners, used too vigorously or too often can eventually mar the enamel. Be careful not to loose the small parts. Soiled electrodes may cause malfunctions when igniting or flame control disturbance. [. . . ] · Turn the black plastic part so that the recess is above the nozzle. Screw out nozzle and take nozzle out with small pliers. · Replace both low setting nozzles on the gas taps according to the new gas type and as detailed in the low setting nozzle table. Fully screw in the new low setting nozzles. [. . . ]