User manual GAGGENAU VG442210

[. . . ] Operation, Maintenance and Installation Manual VG 442 Gas Cooktop VG 442 1. Important Notes For Your Safety Operating for the First Time About Use 2. Features Features of the Appliance Control Knob Burner Parts 3. Installation Instructions Important Notes on Installation Connecting the Appliance Preparing the Cabinet Installing the Control Panel Installing the Cooker Nozzle Replacement Fitting the Appliance Cover Page 3-4 Page 3 Page 3 Page 4 Page 5 Page 5 Page 5 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10-11 Page 12 Page 13 Page 14-15 Page 16-23 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21-22 Page 23 1 Congratulations on buying your new "Vario" appliance. [. . . ] Never switch on the cooktop while cleaning. Keep the ventilation openings on the rear of the appliance clean. 10 Part / Material Pot Grid (enamel on cast iron) Burner Head Cover, Burner Ring, Burner Head (brass) Base (stainless steel, shot blasted, brushed) Suggested Cleaning Procedure Take pot grids off for cleaning. Remove coarse soiling with damp cloth and detergent. Use brass polish to keep the original shiny surface. Soak burnt-in remainders with a little detergent solution. After cleaning, polish dry with a soft cloth to prevent water stains forming on the surface. For heavy soiling, you can order our stainless steel cleaner (Order No. Caution: no liquid should enter the housing of the cooktop through the burner base. Important Reminders Do not clean in a dishwasher. Abrasive cleaners, used too vigorously or too often can eventually mar the enamel. Be careful not to loose the small parts. To prevent marring the polished stainless steel trough, always polish in the direction of the polish lines. Light discolorations may form if the natural oxidation is removed together with the soiling. Put some commercially available stainless steel polish on a cloth and polish the whole cooktop after cleaning to get an even stainless steel surface. Never allow food stains or salt to remain on stainless steel for any length of time. Important: certain stainless steel cleaners will scratch the surface. Chlorine or chlorine compounds in some cleaners are corrosive to stainless steel. Cloth should not be too wet, as moisture could penetrate behind the control knob. Control knob Wipe with a damp cloth. 11 8. Maintenance After prolonged operation, the burners (burner head cover, burner ring and burner head) will become darker through natural oxidation. You can remove this discoloration as follows: Mix equal parts of white vinegar with a max. 8 % acid (household vinegar) and warm water. Soak the discolored burner parts for no longer than 10 minutes in the solution and remove stubborn stains with a cloth or sponge. [. . . ] The nozzles needed for the gas type to be set are available as a conversion kit. Please specify the appliance type and the required gas type. The nozzles can be changed on the installed appliance. Loads for all gases For all gas types and pressures, the rated load is achieved by installing the high setting nozzles for the required gas type. [. . . ]