User manual GAGGENAU VL430107 annexe 1

[. . . ] And now we wish you lots of fun with your new hob ventilator. VL 430 2 1. Important notes For your safety Do not operate the appliance if it is damaged. The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. Make sure that connecting cables do not come into contact with hot cooking surfaces. [. . . ] 1 = Low speed, the flaps open 2 = High speed = Approximately 10 minutes run-on time on level 1. Then, the hob ventilator switches off automatically and the flaps shut. Ideal for ventilating the kitchen after cooking. Switching off Press the 0 key. The flaps shut slowly after a few seconds. Note: ­ Do not push the flaps closed. ­ Do not place any objects onto the flaps. ­ If you have a combination of VL 430 and 431 and the flaps are open on one ventilator and closed on the other (for example an object is stuck in the flaps): Remove the object, press the 1 key. 6 4. Cleaning and care The grease filters must be cleaned on a regular basis (at the latest after 30 hours of operation). Cleaning the grease filter · Switch appliance to level 1. · Push the flaps towards the front and carefully lift them up on the rear. · Turn the two retaining hooks on the sides up and remove the metal grease filter. You can clean the metal grease filter in a dishwasher at a maximum temperature of 55 °C. Place the grease filter in the dishwasher with the opening pointing down to ensure that no food remainders will stay on it. Insert in the reverse order as follows: switch appliance to level 1. Insert the grease filter and turn the two retaining hooks down. Insert the flap pins on the front into the hole and hook in at the rear at the correct angle. Cleaning the flaps Do not clean the flaps in a dishwasher. Cleaning the frame and the membrane key pad Apply commercially available window cleaning agent with a soft, moist cloth. Note: do not use any strong, caustic or abrasive cleaning agents. Do not use any abrasive sponges or brushes either. 7 5. Assembly instructions Important notes on installation The appliance must only be connected by an authorised specialist. The specialist is responsible for perfect functioning of the appliance at its installation location. [. . . ] · Connect the appliance to the fan module by means of the 4-pole plug. We recommend the use of our telescopic wall box TM 180-043 to route exhaust air through the outside wall. Installing the edge trim AL 400-000 The edge trim has to be fitted to the side of the hob ventilator, if this ventilator is installed together with other Vario appliances and forms the left or right edge of this combination. The edge trim does not change the total width of the cut-out, however, the width of the edge trim has to be added to the total width of the appliance combination. [. . . ]