User manual GAGGENAU VP421111

[. . . ] Operating and Assembly Instructions VP 421 Teppan Yaki VP 421 1. Important Notes For your safety Operating for the first time About use 2. Features Features Special accessories Operating principle 3. Operation Switching on Switching off Residual heat display Keeping warm setting Holiday safeguard Visual signals Settings table Practical tips 4. [. . . ] Note: do not hit the frying surface with the spatula. Switching off Fully turn the right control knob to the OFF position. Residual heat display After switching the right control knob to the OFF position, the luminous disc behind the control knob will flash until the appliance has cooled down sufficiently to be touched safely. The appliance must not be touched until the residual heat display has gone off!Do not close the cover (special accessory) until the appliance has cooled down completely! Switching off 6 Keeping warm setting Keeping warm setting Turn the right control knob to the keeping warm setting. Use the left control knob to select the desired heating zone. You can select the whole frying zone, or only the front or rear part. The keeping warm setting enables you to keep food warm after frying. Holiday safeguard (Automatic switch-off) The appliance is set to automatically switch off 4 hours after the last operation. The luminous disc behind the right control knob flashes. Now the appliance can be switched on again as normal. 7 Visual signals Luminous disc behind the left control knob Luminous disc behind the right control knob lights OFF lights constantly slow flashing slow flashing fast flashing Signification Cause / Remedy appliance is switched OFF appliance is ON appliance is ON, heating up residual heat display holiday safeguard normal use normal use The appliance is too hot to be touched safely. The appliance setting has not been changed for over 4 hours. Turn right control knob to 0 and then switch on again if required. After a power cut, the appliance stays switched off for safety reasons. Turn control knob to 0 and then switch on again if required. Connecting cable between the appliance and the control panel is not plugged in. Check that cable is plugged in firmly. fast flashing power cut fast flashing of faulty installation both control knobs alternately 8 Settings table Temperature Meat / Poultry Rump steak 240 °C 3­6 min. 800 g) The steak is medium, when meat juices appear. For longer frying times (well-done) reduce the heat setting to 230 °C after searing. For longer frying times reduce the heat setting to 230 °C after searing. Time Quantity Remarks Roast neck of pork 240 °C 5­6 min. 800 g) Veal cutlet Swiss sautéed veal / stir fry Minced beef Sausage Lamb cutlet 190­200 °C 240 °C 240 °C 190­210 °C 210­220 °C 12­14 min. 600 g) 600­700 g 600­700 g 10­30 min. [. . . ] Several appliances can also be installed in individual recesses, as long as a minimum clearance of 50 mm is kept to between the appliances. · As shown in the installation sketch, drill the Ø 35 mm holes to secure the control knobs in the cabinet front. · If the cabinet front is thicker than 26 mm, the front must be routed from the back to max. 5 05 min. 1 , 5 62 max. 1 90 360 60 765 1170 1575 80 x 310 D = 26 D > 26 16 ­ 26 15 Installing the control panel Note: only install control panel with appliance of the corresponding type. [. . . ]